McCulloch FHH25A Gas Pressure Washer "new engine stalls" Questions

engine Last time I tried to use the washer I had had to keep the trigger pulled on the gun other wise it would build up to much pressure between the pump and the gun and would stall the motor. Also if

...engine is brand new. I believe its the the oil sensor. The engines are equipped with a low oil sensor and when you go around turns, accelerate, decelerate, the oil will flow from side to side and ...

...Engine code is: 1 OH902 / 0113E1. I checked the air cleaner (seems clean) and primer (squirts fine) and cleaned the plug. Unit is not run very much. This is the first time I have tried to start it ...

...new one. The motor starts when you pull the trigger it stalls the engine, it seems to have pressure but quits right away It's the spark plug more than likely. If engine turns but won't stay running ...

...engine would start run for 20 to 40 sec.start to hunt than stop oil is new at correct level even unplugged the level device, the same results. ordered a new carb. installed it same results taken cap ...

...keep using it, all you have to do is keep trigger pressed, and when you are cranking engine, depress trigger with the free hand. Can be repaired, but the fix probably will cost more than a new

...compression it did when new, replacing the carb will probably fix your problems. Be real sure about the compression, an engine with low compression and a funky carb might just as well get

...engine there were two bearings one was a needle bearing and the other hidden behind the shaft which was large roller bearing I change them put it back together and the jet wash is just like new it is ...

engine stalls out while using pressure washer nozzle Pump issue. There is not much you can do but try spaying silicone into pump output port to loosen up the bypass and load valves. If no glory you ...

...water, is essential of course. If its brand new and this is the first starting, I would call Husky. Check oil.. The engine has a governor on it, so it should be sounding like its trying to not