Honda Maxus Pressure Washer MX5222 "blockage" Questions

...it out of the wand and clean it out the pulsations are from the pressure regulator unloading from a blockage ( same as taking you finger off the trigger ) coming and going in the jet as the jets ...

...hose at the pump side. see if water is avctually running out of this line. If it is the there is a blockage in the gun If now water isw flowing when the unit riuns without the gun then the blockage ...

...just letting engine run a while to build up pressure, but no luck. sounds like you have an inlet blockage to the pump or not enough volume to feed the pump. make sure hose is turned full on when ...

...relief valve open the o-ring was tore, but I don't think this is the root issue... this indicates a blockage in the wand nozzle or jet the bad "o" ring may be the cause of the blockage or it may not ...

...on/off lever and see if fuel runs out of the hose, it should.  If not, you probably have a blockage in the hoses, the on/off valve is blocked with debris or sludge, or the small bronze filet ...

...is sprayed into the air cleaner Hello, The symptoms you describe indicate that there is a fuel blockage, this could be in the fuel tank itself or an inline fuel filter, the most common would be

...wand the motor returns to the normal rpms sounds like you have either a sticky unloader valve or a blockage causing back pressure to pump causing excess load to engine,a possibility is to check the ...

pressure just fine but when i switch it to high pressure it just dribbles out. Why It sounds like a blockage in the high pressure nozzle

...the handle the pressure surges. Hi: The first thing i would do is be sure there is not a partial blockage in the

the motor have rust in it??the motor can be replaced at a rough guess I would think that there is a blockage in the wand jet at the end or the hose has a blockage inside it