Cuisinart DGB-600 Coffee Maker "hole back" Questions

...sticking out of the bean holder and on the coffee maker where the bean holder goes there is 2 holes, take the bean holder and put one piece of plastic in the coffee maker holes at a time and it ...

hole in the back that perhaps something like a plug in it before. Is there a piece that is supposed to go in there and if so where do I find one? if the hole is near the top it is an overflow hole- so

water pours out of the back Hello, If it is like mine, you will notice a small hole in back at top. If I overfill, water will run out the hole.

...back together. Of the three holes for the screws, there are two smaller and one bigger hole. Align the larger hole on the filter and the base, and the tiny plastic bit and the spring go in to the ...

...machine, take a screwdriver in the hole lokated in the left lower side and a other in the hole lokated in the right top corner. Now should the machine do her selftest and go back to start

leaks from hole in back too much water added,the hole is there for overflow

...hole in the filter holder just fine but when I put the filter back on, the holding screw blocks the flow and nothing comes out. Is the water only supposed to flow through the center hole or does it ...

Keurig Espresso not making holes in Lavazza pods on back. When I try to make a cup of coffee the water just goes into the bottom of the spill section. No water or coffee in my cup. I noticed that the ...

...the milk rise up try to keep the hole above it. If you keep it exactly on the surface of the milk then big bubles will **** back again and become smaller and finer and your fioam stronger and

...hole had popped out, and after tamping it back in it solved the problem. The valve is supposed to keep the hot water from going back up into the reservoir. Without it the water backs up, causing the ...