2008 GMC Sierra 1500 "led brake lights" Questions

...as the airbag system. Try putting the original standard globe back in. If the airbag light goes out, then that will be the problem. you will not therefore be able to use the LED in that brake

...LED brake lights that are part of the tail light assembly. you have to replace the whole assy. There are two screws that hold the assy in, they are both covered by white cable clips. The clips just ...

...brake wire, LED lights with park light switched ON. LED immediately goes OFF the moment the brake wire is reconnected. Again, perfectly working using the conventional bulb. Already cleaned the gound ...

...peddle then fine the +12 volt on the wire and hook it up to the brake led circuit.(only the brake circuit should be on) hope this help you. . On most LED taillights the earth wire is WHITE NOT

...LED) tail light and brake light No 'year make model' as required in all questions, but unless your vehicle came with LED Lights you can just swap because the functions are controlled by the BCM ...

...brake lights. If it is not working check for a bad bulb. If the assembly is LED, check for power and ground at connector to light. If power and ground ok, suspect defective LED assembly Vehicle ...

...LED bulbs, brake/tail/turn lights with the right size, now my brake lights stay on really faint and they light up bright when I step on brake pedal. The lights turn off when I turn off key switch, ...

LED brake lights...Each LED drops 3.6 Volts...You can run a maximum of 3 LED's per resistor...If you have more than 3 LED's run them in parallel with each set of 3...Each run of 3 requires it's own 50

...brake lights when I put a old led bulb in the blinker worked on the opposite side now with the old bulbs in I No brake lights and no blinkers now. When I replace the ball with an LED 1 side works the ...