Hobart 25 in. LXIH-4 Built-in Dishwasher "dw 120" Questions

Ad

Question about Indesit Dishwashers

1 Answer

...door after the fill cycle and see if you have about 1/4-1/2 inch of water by the edge of the tub. check that the water in the DW is hot (higher than 120 F) last, you may have a box of old DW ...

Ad

Question about Frigidaire Dishwashers

2 Answers

...DW. The "Safe Temp for house hold hot water is between 120 7 125 degrees. plenty good for washing dishes the high temp wash and rinse I've been told was put on the DW's to lessen first year repair ...

Ad

Question about Whirlpool Dishwashers

1 Answer

...DW. If you have water pressure, then check for voltage (120) at the valve with the timer calling for water. ( start of cycle). If you have voltage and pressure, replace the valve. If you don't have ...

...DW. I have it set to "high temp" but when I check the temp it is still 80F. I cannot find a schematic drawing to find out where the heating element is as it is not inside the dishwasher cavity. HELP ...

...dw.This is different from the main board. This is most likely the culprit and can be checked with a voltmeter. You should have 120 volts coming out of the filter board if it is working. If not, that ...

...DW is greater than 120 you will need to turn it down further...as the DW has an assist feature in it that heats the water further...you may also need to try the wash in a different mode if there is ...

DW is ready for another cycle. For running continuous cycles, the incoming water will need to be 140 degrees. If you pause 2 minutes between cycles, the temp should remain consistent with a 120 degree

Question about KitchenAid Dishwashers

1 Answer

...DW. The pump will be in front of you. Use a volt meter to check for power to the pump. If there is power,remove the pump and check for a blockage. If no blockage you can make a 120 volt test cord to ...

...120 to 140 deg . and run water till ist hop before starting dw . set the dw for pot & pan or a cycle that uses heat . if you have hi tempt wash use this button . and hi tempt rinse if it has it . ...

...DW or on top of dishes in bottom rack never washed. Make sure water is at least 120 degrees F. As a test run water from the kitchen faucet closest to the dishwasher until it is a hot as it will get, ...

Not finding what you are looking for?
Hobart 25 in. LXIH-4 Built-in Dishwasher Logo

25 questions posted

Ask a Question

Usually answered in minutes!

Top Hobart Dishwashers Experts

Cindy Wells

Level 3 Expert

6688 Answers

vince

Level 3 Expert

2530 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hobart Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...