Where is your fuse box located? Should be close to the fuse box. Have you checked the glove compartment for the OBD connector?Where is your fuse box located? Should be close to the fuse box.
Have you checked the glove compartment for the OBD connector?
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Fixyahttps://www.fixya.com > ... > MPV > 1998 Mazda MPV
Your ground wire connection for the OBD2 connector is located under the dash just below and to the right of the heater controls. More likely that you dont have ...
..
It is OBD II all cars world-wide were required to be OBD II by the 1997 model year. The port should be located under the dash on the drivers side of the car. It looks like a serial port on the back of a home computer.
OBD DIAGNOSTIC LINK CONNECTOR2000 Buick Park Avenue 3.8L SFI OHV 6cylthe OBD Diagnostic Link Connector is located:
Front seating area, driver side, under dash, mounted under dash on driver side
2000 Buick Century 3.1L SFI OHV 6cylthe OBD Diagnostic Link Connector is located:
Front seating area, driver side, under dash, mounted driver side of steering column
Just as reference; if you will send the specific year and model we will can confirm or posted additional details.
Hope this helps (remember to rate and comment this).
For1999 Oldsmobile Aurora 4.0L SFI DOHC 8cylthe OBD Diagnostic Link Connector is located in
front seating area, driver side, under dash, mounted under dash on driver side.
Hope this helps (remember to rate and comment this answer).
Look under the dash near where the steering wheel is usually located (on the driver's side).
Was this vehicle marketed in the U.S.? 1996-97 MODELS NOTE: These models require the use of the Toyota's hand held scan tool or an equivalent OBD II compliant scan tool.
Prepare the scan tool according to the manufacturers instructions.
Connect the OBD II scan tool, to the DLC3 under the instrument panel.
The DLC3 on the 1996-97 models is located on the drivers side under the dash
NOTE: When the diagnosis system is switched from the normal mode to the check mode, it erases all Diagnostic Trouble Codes (DTC) and freeze frame data recorded. Before switching modes, always check the DTC and freeze frame data and write them down.
Turn the ignition switch to the ON and switch the OBD II scan tool switch on.
Use the OBD II scan tool to check the DTC and freeze frame data. Write them down.
Compare the codes found to the applicable diagnostic code chart. If necessary, refer to the individual component tests in this section. If the component tests are OK, test the wire harness and connectors for shorts, opens and poor connections.
The 1995 Sable uses the old OBD l PCM (powertrain control module). It
is located under the dash behind the glove compartment. If you are
removing the PCM the electrical connector is on the firewall inside the
engine compartment. There is a small bolt in the connector that you
loosen as the connector is being pulled out. If you are looking for the
diagnostic connectors, they are on the passenger side near the
firewall, in the engine compartment.
Where is your fuse box located? Should be close to the fuse box.
Have you checked the glove compartment for the OBD connector?
×