20 Most Recent
2001 Yamaha SR 125 - Page 2 Questions & Answers
Yamaha sr250k 1992
be a little more specific , is your battery dead and not enough to turn the starter if the battery is good test your wiring to the ignition and starter when you put the key to start ck to see if you are getting power to the solenoid if so , then your solenoid is bad , you can change it or get a new one , jump it out and see if it starts that way to ck your wiring too,
Will not tick over
hello,
check your intake for air leaks. i have seen a loads of cracked rubber inlet.
check valve clearance and compression.
make sure you have a good battery and the charging system works.
How do i fix the timing adjustment screw to the bike?
Well, There is no screw to adjust valve timing, no screw to adjust ignition timing. No fuel injection. Can you describe what exactly it is your trying to do? It's a 12 HP engine. Very simple to trouble shoot, just need accurate info.
No light on clocks
yes there is a bulb in the speedo, though i'm not entirely familiar with this model but i guess you should take down the speedometer and take of it's case....there you should see the bulb .
Yamaha sr 125
Various sensors are read by the ECU. When the ECU encounters a reading outside the parameters for a given sensor, the warning light for that system is triggered and light associated with that system is illuminated.
Petrol coming out my overflow
Needle valve and seat in the carburator dirty or worn. Best to replace the needle and seat assembly.Kind of works like a toilet. When the float gets to the top, it shuts off the fuel. Any debris or damage in the needle/seat assembly will cause it to overflow.
Not finding what you are looking for?