SOURCE: automatic seat belt removal and replace with regular seat belts
You'd need to pickup the need parts at the junkyard. You'll need the "A" to "B" pillar trim, lower "B" pillar trim, front seat belts and seatbelt giude from a 1995 SC1 or SC2.
The treaded hole in the frame of the car where the track of the automatic seatbelt assembly attaches is in a slightly different place than the three point system. Its not a problem though. You just need to drill a 3/4" hole slightly above the existing hole in the trim panel. The existing hole is hidden by the seatbelt and not noticable at all.
Everything else pretty much bolts or snaps into place.
I've done this swap on several 1991-1994 Saturn S-Series.
SOURCE: Removal of rear window
The bad news is when the cable comes loose it normally means some plastic retaining part has broken, so you will need a new or at least a replacement regulator (which is the cable mechanism that rolls the window up and down). This will bolt both to the door and to the window. I would leave the window in the door and just tape it up once you have it unbolted from the regulator.
SOURCE: I need to know how to install an idler pulley for a 1995 Saturn
Getting the belt off is the tuffest.. Thats all I can say lol
SOURCE: 2001 saturn sc2 gets code 341&340 camshaft sensor
if you have high resistance in secondary ign. system (plug wires, ign.coil) this will cause this code to set. make sure you are using a high quality spark plug wire set. not from autozone!!! and denso non platinum tipped spark plugs. also use a diaelectric grease on plug wires to keep moisture out.
SOURCE: install seat belt through seat belt guide 1990 camaro
The new seat belt guides will have a **** in them that allows you to put the belt through it. If it's a used guide taken off another car it may not have the ****.
53 views
Usually answered in minutes!
×