I'm not sure of the firing order. All of the spark plug wires were taken off at the same time. I found the numbers for the wires on the coil pack but need the number order of the wires for the motor. 1995 Mercury Mystique V6

no year car told. (will Assume starter cranks fast)
NO SPARK (fire only happens with fuel) fueling is last.
when did it last run this car, last week, month, year, ? or never
as in fixing dead car for friend ,etc? for found a dead car?


spark that is called,the High voltage HV ) spark coil makes spark happen on all gas engines. and evolved radically from 1990 to now.
so your not telling cars year, country, makes answer frankly impossible
Generic answer next. (4cyl. 1.3L)

• fuses blown. (we check them all, )
• icm bad, or bad distributor. or installed wrong.
• 2 coil packs,? 1,3,4,2 fired, and wired backwards (OOPS)
• COPS bad. (coil over plugs x4)
• CKP bad
• CMP bad
• cam belt slipped making CMP and CKP LIE and ECU ignores them. or fires sparks in WRONG TIME.(varies by year made)
• wires bad to all that. or connector, there.
• key switch bad (ing pin)
• bad spark coil HV,or HV wires sets bad. to distrib or to coil packs.
• always test all spark plugs not just one., or bark up the wrong tree easy.

if 2 coil packs the HV lugs most not connected wrong,
or spark firing order is lost.
if 2coil packs, 1 spark plug or 1 HV wire fails 1 spark plugs die
and 4cyl with only 2 sparks good cannot RUN.
1,3,4,2 is order.

1983 to 2011 years wiki says

The Ford Bantam is a coup? utility/pickup (known in South African English as a 'Bakkie') produced in South Africa. Production of the Bantam spanned three generations, with the vehicle produced in South Africa for sale within the South African market.

Brazilian-designed Rocam engine is of single overhead-cam configuration with two valves per cylinder.
2002 to 2006, it says.
Zetec Rocam (Duratec 8v) was cam chain driven, but I'm not sure, none sold here.USA

theres no distributor and the firing order for your 3.8 is 1-6-5-4-3-2-the following link shows the coil pack
Buick General Motor 3800 V6 Engine Firing Order DIS IDI ignition timing 3.8 Buick Engine Coil Pack Firing Order Spark Plug Wire Location Which way do the spark plug wires go on & what cylinder is what?
.
For the Buick V6 231 3.8 liter turbocharged engine:
.
Answers!
.
Firing order:
1 - 6 - 5 - 4 - 3 - 2.
.
Spark plug wire location on coil pack:
.
Closest to the back of the car, left to right: 1 - 5 - 3.
Closest to the front of the car, left to right: 4 - 2 - 6.
.
Spark plug wire location on engine:
.
drivers side, front to back of car: 1 - 3 - 5.
passenger side, front to back of car: 2 - 4 - 6.
.----and this link shows the coil pack to cylinders
.
3 8 Buick Turbo Engine Coil Pack Firing Order Spark Plug Wire Location

CHECK YOU FIRING ORDER, YOU MIXED THE IGNITION WIRES, IF IT IS A 4 CYL, FIRST CYLINDER #1 IS NEAR THE BELTS, CHECK COIL WIRES FOR NUMBERS, OR DISTRIBUTOR CAP FOR CYLINDER NUMBER OR COIL PACK FOR CYL #, AND FOLLOW THE WIRES TO THE SPARK PLUGS. MAKE SURE THEY ARE RIGHT, NEXT TIME DO ONE PLUG AND ONE WIRE AT THE TIME.

STANDING FRONT OF VECHICLE CYLINDERS FACING YOU ARE 4 5 6 AND BACK CYLINDERS IS 1 2 3 NOW ON PIECE PAPER LOOKING AT IGNITION COIL PACK FACING YOU WRITE BACK NUMBERS 123 AND UNDER THAT NUMBER 1 2 3 WRITE FRONT NUMBERS 5 6 4 THATS YOUR COIL PACK PLUG WIRES LOCATION. LIKE I SAY 5 6 4 IS PLUGS WIRES LOCATION FACING YOU AND BACK NUMBERS 1 2 3 PLUG WIRES LOCATION ON COIL PACK. FIRING ORDER IS 1 4 2 5 3 6

HI. There are several areas of concern here. I will list them below. Check all areas stated in the list for faults.

Possible cuases:

1. Incorrect firing order set. On the 2.0, 2.4 and 2.7 engines. These engines are equipped with a distributor-less ignition system. This system incorporates a coil pack assembly, along with wire sets. In order for the assembly to fire correctly, the order of the wires must be set to the proper sequence. if not, the engine will not turn over, or start correctly. Make sure your firing order is correct, and make sure you have not placed a particular wire set into the wrong cylinder. I will post a picture of the correct firing order for your engine, below this list, shortly.


2. Incorrect spark plug gapping procedure. If the new spark plugs were gapped incorrectly, this will not allow for proper spark, thus, preventing optimal combustion, due to lack of fire. Check the spark plug gap using a wire gap gauge, and adjust if necessary. The gap should be 0.039-0.043 in. (1.0-1.1mm)

3. Failed coil pack assembly. This will be the worst case scenario. The coil pack supplies the necessary current that fuels each plug. The current is transferred, via wire sets.This will be the culprit if all the above areas are proven to be operational, and in good shape.

4. Failed wire sets. Replace the wire sets if faults are found at the connector at the ignition coil pack, or at the plug boot.



NOTE*
In order to provide the correct firing order for your engine, i will need the engine size and liter information, if possible. Please post this information, asap. Thanks..

The cylinder order is 1,2,3 (rear row, left-to-right) and then 4,5,6 (front row, left-to-right).
When replacing spark plug wires or plugs, it's very helpful to do one at a time to avoid connecting them incorrectly.
Hope this helps, Sherwin

The COIL PACK TOWERS are numbered : coil----3---4 pack---2---6 plug----1---5 ----------------------------------------------------------------- The engine cylinders / spark plugs are numbered : passenger side , front to rear , 1 , 2 , 3 -----drivers side , front to rear , 4 , 5 , 6 ------------------------------------------------------------------- The spark plug firing order is ( 1 -4 - 2 - 5 - 3 - 6 )

found this online hope it helps

If it's the four cyl., the first coil pack bolts over the #2 spark plug. The #2 coil pack wire plugs into #3 spark plug. The number two coil pack bolts directly over the number four spark plug, and the #2 coil pack wire plugs into the #4 plug. The firing order is 1-4-2-3.

2.3 and 2.4 has idi ign.syst. mounted directly on top of plugs,2.2 coil pack cylinder numbers are marked on it,from left of elect. connector on coil pack is 2-3-1-4where spark plug wires go,on block, cyl. from drive belt side is 1-2-3-4,timing firing order is1-3-4-2