Shift Solenoid c Where and how to replace in A 99 plymouth Voyager
There are only a few connectors that need plugged in. The first one is the solenoid pack which has eight wires and a bolt that goes through the connector. then the range sensor which will be located by the shifter shaft, will have either round or flat spade like pins. The wiring is the same only difference is the connnector; you may need to get a matching plug if the new one doesn't match your vehicle's harness. Then there are two speed sensor plugs that are small simple push in plugs that have two wires each. You may or may not have a crank sensor to plug in, if you do it will plug in kind of on top of the bell housing more towards the firewall. That should be it.
I replaced my Solenoid Pack,Speed Sensor Input and Output. But the problem still there.
I tried to reverse the Van but sometimes it will work sometimes not.
I tried to use the Drive but it also will work and sometimes its not.
It just like the gear goin to a neutral mode.
I cannot figure out the problem because the Check Engine is not on.
Do you have any answer for this please.?
×
374 views
Usually answered in minutes!
×