How to remove a stsrter on a 1993 ford ranger

Hi. here's the procdeure on how to remove and replace new starte for your truck.

1. Step 1 Disconnect the battery's negative cable from the battery using the battery wrench.
   
2. Step 2 Lift the right front end of the Ranger with the floor jack and then lower it onto the jack stand. Make sure the jack stand is under the right front frame, but does not impede your access to the starter.
   
3. Step 3 Climb under the Ranger with the socket set and unbolt the starter wiring using the socket set.
   
4. Step 4 Support the body of the starter with one hand while you remove the two starter-mounting bolts with the socket set using your other hand. Do not let the starter rest on the loose bolts at any time during this process.
   
5. Step 5 Set the old starter off to the side and hold the replacement starter in position. Thread the mounting bolts back in by hand and then tighten them down with the socket set. Once again, do not let the starter's weight rest on the bolts until you tighten them down fully.
   
6. Step 6 Bolt the starter wiring to the new starter using the socket set.
   
7. Step 7 Climb out and lower the Ranger off the jack stand using the floor jack. Reconnect the negative battery cable with the battery wrench.
   

You may have to unbolt the motor mount to get strtr out