Go in this order-
-make sure the fluid resivoir is full and the cap on
-crack both front bleeders loose and allow them to "gravity bleed"
-once you see fluid constantly dripping out of the bleeder close them
-do the same with the rear
-after you have gravity bled the brakes grab a partner and have them pump the brake 4 to 5 times holding the pedal down on the fifth time
have them say "holding" while you crack the right rear bleeder-once the pedal hits the floor they should say "floor" and hold it there while you tighten the bleeder. repeat until you see nothing but fluid squirt out.
repeat this whole process in this order
right rear
left rear
right front
left front
make sure to continually check the brake fluid level so it doesnt get too low
this should work unless the master cylinder leaked dry from replacing the lines-if this happened you will most likely have to bleed or even replace the master cylinder
186 views
Usually answered in minutes!
×