How to replace Lincoln ls power steering pump sensor

check out the link

https://www.google.com/search?q=2002+Lincoln+LS%2C+replace+power+steering+pump

..

Then you must have a defective steering rack.

A new fan is needed. It's been turning for 16 years. Time to replace it. Same for the power steering. Depending on where the leak is, if from a hose, a clamp may need tightening. If from the pump, then it's time to replace.

If your power steering pump was bad, you would know all about it from a drivability standpoint. I am unsure exactly what is being asked, but inspect the fluid and physically inspect the power steering pump itself.

Have to have alignment done after any
front end work

Most repair shops don't have that capability
That is why you don't go to them

Still same problem?

Then the whole rack & pump was a questionable
diagnosis & repair

Any thing else you can add

I have a 2004 V8 LS

please rate if this helps. Might find one cheap on ebay.

Power Steering Pump - 3.9L
Special Tool(s) Teflon® Seal Replacer Set
211-D027 (D90P-3517-A) or equivalent
Removal

1. Remove four pushpins and the engine cover.

1. Remove the air cleaner and the air cleaner outlet tube. For additional information, refer to Section 303-12.

1. Remove the bolts.

1. Remove the accessory drive belt. For additional information, refer to Section 303-05.

1. Unclamp and disconnect the power steering reservoir-to-pump hose (3691) and drain the reservoir (3E764) into a suitable container.

1. Position the power steering reservoir out of the way.
   1. Loosen the bolts.
   1. Rotate the reservoir from the insulator.
   1. Pull the reservoir down from the insulator and position the reservoir out of the way.

1. Raise the vehicle on a hoist. For additional information, refer to Section 100-02.

1. Remove the wheel and tire assembly. For additional information, refer to Section 204-04.

1. Remove two bolts, one pushpin and the shield.

1. Remove two pushpins and the shield.

1. Remove the bolt.

1. Disconnect the electrical connector and the wire retainer.

1. Remove four bolts and position the A/C compressor out of the way.

1. Disconnect the power steering pressure hose.

1. Remove the bolts.

1. Lower the vehicle.

1. Remove the bolts and the pump.

Installation

1. Using the appropriate special tool, install a new O-ring on the power steering pressure hose fitting.

1. NOTE: Do not tighten the upper bolts until the lower bolts are installed.
   

dont know but 1 thing for sure i was told to replace the fan , so i had it replaced, turns out now the problem may be the power steering pump , ur fan isnt electrical it is a hydraulic ran fan, and is fead with power steering fluid and runs when power steering pump pumps fluid thru, or as simple as a heat sensor which im gonna replace both

Your power steering pump has probably failed and that is what the squeeking sound is. The power steering pump probably needs to be replaced.

you have a hydraulic cooling fan which is run by power steering fluid, if it isnt working properly then either fan , power steering pump or heat sensor is damaged, the fan isnt electrical at all , not 100% sure about the heat sensor being seperate or being part of the power steering pump

There is a valve you open ,on a hose next to the brake booster,to vent air out of the coolant system.

What has the power steering issues have to do with this??