Where is the ignition control module located on a 1995 mazda 626?

1995 Mazda Theft deterent you dont have one. there is a keyless entry. a ant theft radio deterent. So you probable are having problem starting like turning over maybe the starter is non op or even a dead battery. So what does it do?

If you have the correct tools, maybe 30 to 45 minutes.

under the front seats, do not remember if passengers or drivers

The ignition module is integrated within the ignition coil itself, and the only repair possible is to replace the entire coil assembly. There are six ignition coils, therefore there are six ignition modules.

Fig.: Exploded view of the 2.0L engine coil pack assembly




Fig. : Exploded view of the 2.5L engine coil pack assembly



Hope this help (remember comment and rated this).

The thermostat is located on the engine block, where the upper radiator hose connects to the engine. You'll see a large elbow-like component that is attached to the engine with 2 bolts.
Just follow that upper radiator hose and you got the location. When you remove that housing (elbow-like component), you'll see the thermostat.
Make sure you note which end of the thermostat is up and which end is down. Don't reverse the install.

Hi, common thing with the mazda was the coil or the ignition amplifier going faulty, both of which are located within the distributor, the coil ususally gives the symptoms you describe, a weak spark. The coil is the most common failure aswell for your vehicle i would recommend a new one, also make sure distributor is spinning as it could just be a case of a broken timing belt.

Good luck Davelee

best i can tell you is under the left side of the instrument panel.. rather large connector for it as well.

check were upper hose connects might say located at water pump which means its were lower hose connects to engine

if u go on yahoo.com type 1995 mazda 626 timing and click on search images you will see a picture of how to set it.