Can somebody tell me how to remove a panel in Chrysler Vision??? i was trying to get to evaporator but seems to me it that i'll have to remove whole panel off! or is there any easy way to get to evaporator? PLEASE its very URGENT

Presuming you are working on your air conditioner, here is a page that might help http://blog.choppedoctopus.com/2011/02/epic-project-fixing-my-ac.html. Plan on pulling you glove box and working on your head for a bit.

Hello , for heater core or AC evaporator ,, you have to remove the dashboard to reach the housing and replaced them .. no other way

Its likely to be the 21 pin plug behind the heater control panel. Remove the long plastic strip under the control panel (prise of gently, held on by 2 clips) remove 2 screws behind this and 2 screws above on panel. The whole lot should easily come away. There will be 3 plugs, remove all three and try to start the car. If it starts your problem would be the earth. Hope it helps

Immobilizer? Its likely to be the 21 pin plug behind the heater control panel. Remove the long plastic strip under the control panel (prise of gently, held on by 2 clips) remove 2 screws behind this and 2 screws above on panel. The whole lot should easily come away. There will be 3 plugs, remove all three and try to start the car. If it starts your problem would be the earth. Hope it helps

They're held on by a few screws inside the door. You might have to remove the door panel, I am unsure of the 300 how the mirrors are installed. Just look for screws in the door where the mirror is. You'll see if you have to remove anything or not. Maybe the door panel might have to come off. Either way, remove, unplug, then install the new one.

the whole instrument panel(dash)must be removed from vehicle and hvac assembly(heater box)must be disassembled to replace evaporator..a major repair that would even a experienced mechanic 6-7 hours to do..would recommend an hvac repair center to do repair..also wiper module housing should be removed to access heater hoses and a/c lines where they go inside vehicle

Disconnect the battery, if you haven't already, and wait a few minutes. From there just take your time and don't force anything. The airbag needs electrical power to deploy.

Its likely to be the 21 pin plug behind the heater control panel. Remove the long plastic strip under the control panel (prise of gently, held on by 2 clips) remove 2 screws behind this and 2 screws above on panel. The whole lot should easily come away. There will be 3 plugs, remove all three and try to start the car. If it starts your problem would be the earth. Hope it helps.

The problem was in ventilator valve resistor, located below glow box, near ventilator. A transistor replacement did the job!

Yes you do, it is in the dash heat/AC ducts