Need to change left front turn single whole ***. come out?

There is no flasher relay on your vehicle. Turn signals are selected by the multifunction switch (left side of the steering column), but the lights are operated by 'drivers' in the front control module. This unit is in the left front part of the engine compartment, below the power distribution panel. But you cannot change just the 'drivers', if bad, the whole module needs to be replaced.

was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

You have to get the whole circuit for the lights checked by a car electrician or an equivalent expert Charles.

changing front indicator bulb ford focus 02

This is extensive steps to do this which you will need the actual diagrams from the manufacture. We can give them on our site as we pay them to allow us to distrubute them so there is no copyright issues come by and get the info plus help from a Mechanic

http://www.expertcaradvice.com/askquestion.php

This is weird! It seems to me that the left turn signal is getting 12v from somewhere at all times.I don't think the flasher is the problem(most GM systems use a single flasher for left and right)You probably have a crossed wire somewhere(or an add on accessory was connected to the left signal wire,allowing 12 volts to bleed through to the circuit)

If your Beetle is a "Turbo S", the whole front clip (bumper facia) has to come off.

For all other Beetle models:
Remove the screw cap at the rear of the front turn/marker lense.
Remove the screw
Pull the lamp assembly forward
Disconnect the electrical connector
Twist the lamp socket to remove it from the lamp assembly
Remove the bulb
Reverse procedure to install

sounds like a faulty underhood fuseblock..have seen lighting issues with these components

whole unit,remove front bumper to get to bottom bolts

most likely the cv boot is bad will need to be replaced recomend change the whole cv axle