Question about 2002 Jaguar X-Type
Dip beam (outer) headlight
Open the bonnet.
Slide open the two spring clips (A) and remove the cover (B).
Press the spring clip inwards and push towards the bulb
to release the bulb and then remove the bulb from the light
unit. Pull the connector from the bulb.
Fit a new bulb to the connector, type H1 for dipped beam.
Fit the bulb to the light unit, the bulb will only correctly fit in
one position. Engage the spring clips to retain the bulb and then
fit the cover and retain using the two spring clips.
Close the bonnet.
Note: High Intensity Discharge (HID) Xenon light units,
type D2S 35W, are not renewable, contact your Dealer if the headligh fails to operate
Posted on Oct 07, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
did you touch the tip of the bulb with your hand or finger if so replace it again its probably blown out the oils in the skin blow the bulbs because of the heat that they put out.
Posted on Nov 14, 2009
SOURCE: how to change a 2003
Open your hood.Behind the head lamps you will see black plastic covers held with spring clamps. There is one on each side of the assembly (the outer clamps not visible). So reach in and undo the clamps to remove the covers. Disconnect the wire on the headlamp bulb and release the small spring clamps on each side of the bulb. It should come right out. Install the new H1 bulbs and make sure the dimple goes inside the little alignment hole in the housing for alingment. Slight twisting L & R will help you check this until you feel it insert) Install the small clamps. Install the connecting lead wire on the bulbs and install the covers. Make sure to place BOTH clamps on the covers. NOTE: the passenger side is really limited in room to remove the outer clamp. I recomend a long screwdriver to help release it. Re clamping the outer clamp will take some finesing to get a hold of it and bring it forward. I recomend looping a metal wire on the middle to help bring it out and pull it to clamp it.)
Posted on Jan 17, 2011
Tips for a great answer:
Aug 11, 2010 | 2002 Jaguar X-Type
Feb 07, 2010 | 2002 Jaguar X-Type
Feb 02, 2010 | 2002 Jaguar X-Type
Jan 30, 2010 | 2002 Jaguar X-Type
Nov 15, 2009 | 2002 Jaguar X-Type
Nov 14, 2009 | 2002 Jaguar X-Type
Nov 11, 2009 | 2002 Jaguar X-Type
Jul 03, 2009 | 2003 Jaguar X-Type
Jun 23, 2008 | 2004 Jaguar X-Type
886 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: