How to Remove driveshaft on grasshopper on 721d mower need to replace pillar block bearing

SOURCE: mid ship bearing on driveshaft needs replacing.

Not unless you bend the tube. You will have to disassemble at least one U-joint--keep track of how it came apart and all of the little needle bearings in the cups on the end of the cross--keep everything clean. Fresh grease will help keep things together when putting it all back.

Marvin

• 85242 Answers
• Posted on Sep 14, 2009

SOURCE: Need to replace the driveshaft support bearing and

call the dealer or go down and point out what you need on the parts breakdown page, it will show an exploded view of everthing in the drive line.

SOURCE: how to remve driveshaft center support bearing on

Hi:
You need to take your driveshaft to a shop to have the bearing pressed off and the new one pressed on. It can't easily be done at home. My local shop only charged me $15 to do the job.

SOURCE: 2005 ford escape 3.0l AWD XLT - DRIVESHAFT CARRIER

if there is some one in your area that balances driveshafts they can change just the bearing for you

SOURCE: how do I replace the driveshaft bearing support?

You jack up the truck, and support it on jack-stands. (no wheel must touch the ground, for safety).
Remove the two front tires for visibility.
Put the tansmission in neutral and apply the handbrake.
Get under the truck and in the area of the support-bearing, mark the position of the driveshaft to the flange, which has 4-bolts.
Remove the 4-bolts.
Pry off the driveshaft with a flat-end screwd-river.
Remove the bolts holding up the support bearing.
Drop it down and pull off the support bearing.
Reverse these procedure for installation.