Number 10 Fuse blows when vehicle is put in reverse. and signal lights are stop working. what ca cause this issue?
SOURCE: no brake lights blows fuse every time
there is most likely a short in the wires have you put a tow package on it if so did you splice in to the lines check all wires and see if they are burnt any were most likely short
SOURCE: fuse blows when shift in reverse
Am I correct, the turn signal fuse is blowing when you put the manual shifter in reverse?
Let me know.
Regards
SOURCE: Meter 10 Fuse Blows when I go into Reverse, Instrument Panel too!
short in shift column...have mechanic look at it
SOURCE: large 20amp fuse keeps blowing
Change the fuse for the correct size AMP.
More details about Power Center Distribution, check the Section 8W Wiring Diagrams
Good luck.
I had the same problem, 97 4 runner. I followed #1 solution: start engine, lower rear window, raise/close rear window. Turn off engine, restart engine and it should re-set. It did for me.
5,547 views
Usually answered in minutes!
×