SOURCE: how do you install a block heater on a chevy aveo 2006?
A block heater is installed in one of the freeze plug ports in your block. Drain your cooling system. Then drill a small hole i the center of the freeze plug and screw a self tapping screw into the hole. You can the use a claw hammer or something similar to pull the freeze plug. Then you just install the block heater in the freeze plug's place. Refill your cooling system and let it get up to full temperature checking carefully for leaks. Please rate my answer.
SOURCE: no heat on 2008 sienna, replace t-stat. one rad
hello, check and see if it has a valve in the heater core hoses, also take heater core hoses off from motor, their should be two, put water hose on the end of hose run water through one hose, then swap to other hose, run water throuhg it also, you are flushing heater core out see if any trash comes out either hose, check water pump, and thermostat, make sure it is opening, you can buy a bad thermostat, i have before
SOURCE: 2008 Chevy Aveo CD Player Error 7
Hi i have a 2008 chevy aveo the dashes lights up but the radio stations wont whats wrong
SOURCE: replace alternator 2008 aveo
disconnect negative battery cable. Then remove rubber boot on altenator. Remove nut and cable attached. Unplug and remove wire harness also attached to altenator.
Loosen and remove both bolts holding on altenator.
Remove altenator.
Reverse process to reinstall. Pry on belt tensioner with pry bar and socket to loosen belt and place on altenator pulley after it is installed.
Last reattach battery cable and start vehicle.
SOURCE: 2008 chevy aveo brake lights won't turn off
CHECK FOR YOUR BRAKE LIGHT SWITCH IT IS LOCATED BEHIND THE BRAKE PEDAL UNDER THE DASH. FOR A TEST DISCONNECT IT AND SEE.
91 views
Usually answered in minutes!
×