My opel kadett 1995 model it burn the plugs and the fuse what can course that.

Question edited for clarity, spelling and to add maker. Why are you typing in all CAPS, it is rude and considered SHOUTING. Plus it is harder to read.

Your Diktator Management System is a snake oil product. Opel are quite competent at designing and managing your engine. It is supplying more power to the coil in the hope of giving you a better spark. Contact them and ask them what coils the recommend?

https://www.google.com/search?q=DIKTATOR+MANAGEMENT+burns+out+coils

..

fuel level sensor (yes is float)
most of these sensor, well not open here.
there are 2 or 3 wires.
the meters had then a thermal meters.
fuse >>keyon>>>> meter in, meter out >>> sender >>gnd.
if sender is bad voltage to hot pin is 12vdc.key on.
if less it is good like 6v.
my old 91 car had 120 ohms empty and 3 ohms full.
30ohms 1./2 full sender pot.,
so gas full is near 0v. or 1v.
the meter has shut inside,

not opel but old and generic answers.
fails: ?? all answers connected !
fuse blown
meter bad rare
sensor bad common 12vdc on its pin is bad
ground bad super common 12v on this pin ground is bad.
about 6 volts or less is common and good. on hot pin

for truth buy the service manual , like we do.

You must have a vacuum leak check a black tube leak close to the upper intake

Go to your local parts house. They have a free service to hook up to the access cable and read the code that is causing the problem. That needs to be attended to as it more than likely will cause failure creating a bigger problem. They can tell you how to fix it as well. Some even will print it out or you.

Buy a copy of the "Vauxhall TIS" dvd from eBay. These have wiring diagrams for all Opel cars

My opel misses while I drive I replaced the fuel pump spark plugs did the whole motor over and stil the same what can it be?

disconnect the battery for more then 5min, or with the fault code reset tool. all opel dealers have 1.

Conrod torque settings for opel cadett 1.6 gse