Becky, you may be right, as they say, you may have stirred up the hornets nest. They did not really tell you to seafoam the motor pictured, did they?
seafoam is a gas treatment, not an oil treatment
Thanks for clearing that up, I thought they had you put it in engine.
So im *******? Because thats where they told me to put it
They told me to put it in my engine
They told me to put it in my engine drive for about 30-45 minutes then change oil and it would get the gunk off so i did n now my car is messing up
×
SOURCE: Motor Oil leaks from 1999 Honda Civic EX
make sure they are tight
could be time for head gaskets
make sure the old gasket from the old filter came off the block sometimes they come off old filter and stick this causes a leak due to improper seal.
SOURCE: 1992 chevy siverado pickup 350 engine,I have a oil
you definately should check the oil pressure switch its probobly above or to the side of the oil filter and can make it look as if the filter is leaking,it will be threaded into the engnine itself and will have a connector on the top of it most likely with only 2 wires going to it
SOURCE: I had the valve cover gasket changed on my 1996
on a v6 ? Low on oil? rear cam plugs leaking? The lifters are on the end of the rocker arms and may get clogged. I have had some luck running 0w30 mobil synthetic for about a week or so with a new oil filter [Not a fram filter] and after that put 10w30 synthetic oil back in and a new filter. Check for oil leaking at other locations. If the noise is at the front of engine near water pump it may be the hydraulic timing belt tensioner.
SOURCE: my celica is burning oil
Your car is probably burning oil through the piston rings due to wear. The valve cover gasket will show signs of leaking from the space between the valve cover and the head. Remove one of your spark plugs and see if it is black and oily. You can try using a little thicker oil than what you have now or just add a little in as it burns off. Buy a quart of name brand 20w/50 and use that to top off the oil as it burns off. You should notice a difference.
181 views
Usually answered in minutes!
Yes that would b the motor they told me to sea foam i showed them this picture so they knew what i was dealing with and idk much about gunk ....only dont scrape it because if it drops in motor im done for but they said this would eat the gunk on motor and make it better
×