Here's an excerpt from the 2002 Acura MDX 4WD 6cyl Repair guide for replacing what the reference manual calls the "control assembly" - its located under the console rear trim and may (or may not)
contain the blower resistor - my manual doesn't say - but this is the closest thing I could find for you. Every other blower resistor I've had to find was located close to the heater controls - and this
car seems to be no exception -- its heater controls are located in the console between the seats, rather than in the dash (as in Acura 2003-06 MDX models).
You may want to call your friendly Acura dealership ad speak to the parts department, to make sure where the blower resistor is located - or a visit to a dealership parts counter often (or
Advance Auto Parts is helpful too) ofen clarifies questions I have from Haynes manuals (the cheapest car repair guides).
All this assumes that you've correctly diagnosed your blower control problem -- as in "replace the blower resistor when the blower works only on the MAX/Highest setting."
-- begin excerpt from 2001-2 Acura 4wd 6cyl MDX Repair manual --
Control Assembly Removal & Installation
2001-02 Models
-
Remove the console rear trim. Refer to the accompanying illustration.
Fig. Exploded view of the console rear trim
-
Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B).
To install:
-
Install the control unit in the reverse order of removal. After
installation, operate the control unit controls to see whether it works
properly.
-
Run the self-diagnosis function to confirm that there are no problems in the system.
Fig. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B)
--- end excerpt from 2001-2 Acura 4WD MDX 6cyl Repair Manual ---
×