To change bulb
SOURCE: How do you reset the 2012 Fiat 500 oil sensor
With all doors closed, put key in ignition and turn key to first position only, and fully depress and release the accelerator pedal 5-7 times. Pedal must be pressed all the way down and fully released these 5-7 times. I hope this helps!
SOURCE: How to change brake light bulb on a 2014 fiat 500L
https://www.fiatusa.com/download/pdf/manuals/2014-FIAT-500L-OM-1st.pdf
it's in your owners manual page 358 chapter 7
you need a torx 20 screwdriver or bit
Rear Tail, Stop, Backup And Turn Signal Lamps
1. Open the liftgate.
2. Remove the two screws and remove the tail lamp assembly.
3. Remove the four screws (using a T20 driver) and separate the backplate from the lamp housing.
4. Remove the tail, stop, or turn signal bulbs by pushing them slightly and turning counter-clockwise.
5. Remove the backup lamp bulb by pulling straight out.
6. Replace lamps as required and reinstall lamp.
Center High-Mounted Stop Lamp (CHMSL)
This light is an LED assembly. See your authorized stealership
220 views
Usually answered in minutes!
×