How do I relase the tape manually - Cars & Trucks

Your best bet is to bleed the entire system starting with the wheel farthest from the master cylinder, and working to the closest one.
Also, if you have drum brakes on the rear, make sure they are properly adjusted as poor adjustment will cause a "low" pedal.
The cap you refer to with wires is the resivour fluid level sensor, and the ring keeps fluid in and contaminants out.

All Cd players have a small pin hole in the face under the opening. Get a paperclip and push it in the hole top relase the carraige and it can be manually removed

The radio is held in place by spring clips behind the radio face there are two holes in the radio face face that a special relase tool set go through to relase the spring clips, you apply a slight outward pressure on the tools while pulling the radio outward. You can buy the Ford radio radio tools from most any auto parts store for about $5.00

have calipers checked to see if they are stuck,put it in neautral relase brakes,and emegency-parking brake then see if it rolls when pushed,if not brakes are freezing up,check emergency-parking brake for sticking and calipers

The vacuum release is at fault. It is mounted near the emergency brake pedal. It has a silver round type metal vacuum pod attached to it with a vacuum line going to it.

get under the truck and the filter is on the inside of the frame rail just aft of the driver seat, u will need a special tool to relase the fuel lines about $6 from any good auto parts store like NAPA, just ask for a ford fuel line relase tool.

it has tension?? with assistant to pull cable you push down on bonnet and with any luck it will pop up,then oil the mechanism with some engine oil and not that silly wonder spray stuff thats all fish oil

these fuel cleanears don't work well they usually end up making more trouble you just need to burn all the gas the engine has or at least have way and then add new fresher gas it will clean the lines

if you look at the pedal for the emergency brahe there is a small lever that will allow you to by-pass the vacuum operated release,check for vacuum at the hose that goes into the release

The Manual Shift "WORKING" is a Good Sign , In Older Models this would Point to Vacuum Modulator Let Me Do Some Diggin and Maybe Come Up with A Sureshot Hit on EXACTLY what it is Im sure its Relased to A Electronic Modulation od TCM