How do you reset maintenance upon changing oil

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

hi,

this might work

http://www.lxforums.com/board/maintenance/83358-auto-window-reset-procedure.html

jm

Your vehicle is equipped with an engine oil change
indicator system. The "Oil Change Due" message will
flash in the EVIC display for approximately 10 seconds
after a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.

Unless reset, this message will continue to display each
time you cycle the ignition to the ON/RUN position. To
turn off the message temporarily, press and release the
MENU button. To reset the oil change indicator system
(after performing the scheduled maintenance), perform
the following procedure:

1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the ON/
RUN position (Do not start the engine.)

2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.

3. Without pressing the brake pedal, push the ENGINE
START/STOP button once to return the ignition to the
OFF/LOCK position.

NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.

Source: Owner's Manual page 293

Dodge Charger Owners Manual

Your vehicle is equipped with an engine oil change
indicator system. The "Oil Change Due" message will
flash in the EVIC display for approximately 10 seconds
after a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.

Unless reset, this message will continue to display each
time you cycle the ignition to the ON/RUN position. To
turn off the message temporarily, press and release the
MENU button. To reset the oil change indicator system
(after performing the scheduled maintenance), perform
the following procedure:

1. Without pressing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the ON/
RUN position (Do not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pressing the brake pedal, push the ENGINE
START/STOP button once to return the ignition to the
OFF/LOCK position.

NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.

Source: Owner's Manual page 293

Dodge Charger Owners Manual

It is probably the change oil soon light. It needs to be reset manually at every oil change. Here is how:
http://oilresetpro.com/how-to-reset-oil-maintenance-life-on-2011-2013-chevy-cruze/

There is also a mobile app for your phone that has all the oil maintenance light reset procedures from these guys. Hope this helps!

there is no light for emissions testing on this vehicle. there is a ses light that can come on, indicationg a problem with the engine or transmission electronic system. this will require a scan tool to pull trouble codes. there is another light called oil life monitoring that needs to be reset after oil changes, which I suspect is what you are seeing. here is a picture of the light and the instructions for resetting.,

The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL SOON message being turned on, reset the system.
After changing the engine oil, the system must be reset as follows:

1. Turn the ignition to RUN, with the engine OFF.
2. Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalization menu.
3. Press the information button to scroll through the available personalization menu modes until the DIC display shows OIL LIFE RESET.
4. Press and hold the reset button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
5. Turn the key to LOCK.

If the CHANGE ENGINE OIL message comes back on when you start the vehicle, the Engine Oil Life System has not reset. Repeat the reset procedure.

1993 BROUGHAM & 1993-96 FLEETWOOD
Oil Life Indicator
1. Oil life indicator will display CHANGE OIL when oil change is needed, based upon engine oil temperatures and driving patterns. After changing oil, reset
oil life indicator.
2. To reset, turn ignition switch to ON position. Do not start engine. Fully press and release accelerator pedal 3 times within 5 seconds. If CHANGE OIL light
comes on and stays on for 5 seconds, it did not reset. Reset system again.

Nissan/Infiniti
Owners of many late-model Nissan and Infiniti vehicles have the unique privilege of actually setting the interval at which they would like to be alerted about changing oil. To do so:
1. Push the "MAINT" button on the main menu.
2. Select "Engine Oil" and push Enter.
3. Select "Maintenance Schedule" and push joystick right or left to select desired mileage.
4. To reset maintenance interval, select "Reset" and push Enter.
To reset the maintenance reminder, follow this procedure:
1. Push the "MAINT" button for more than 1.5 seconds.

RESETTING THE ENGINE OIL LIFE INDICATOR
On LX and EX models

If maintenance is done by someone other than your dealer, reset the maintenance minder as follows:

1. Turn the ignition switch to ON ( II ).

2. Press the SELECT/RESET knob until the engine oil life indicator
is displayed.

3. Press the SELECT/RESET knob for about 10 seconds. The engine oil life indicator and the maintenance item code (s) will blink.

4. Press the SELECT/RESET knob for more than 5 seconds. The maintenance items code (s) will disappear, and the engine oil life indicator will reset to "100".

press maintanence button until you see engine oil, then hold trip/reset button... :)