2005 Hyundai Terracan 2.9 Logo

Related Topics:

A
Anonymous Posted on Aug 12, 2014

What is the pin layout for a delphi 39101-4x740 ecu

I need the location of all the negatives on the ecu

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
1answer

Were is the ecu fuse on the 1999 Mitsubishi montero sport

The ECU fuse should be in the main fuse panel, Located under the hood close to the battery on top of the inner fender. The fuse layout is printed on the lid. What are your symptoms? The ECU very rarely goes bad and is very expensive
0helpful
1answer

What is the iat pinout layout for 2002 sante fe 2.7?

Unless you find free info on a web site, you have to
pay for reference material like that

That is why I buy all the factory manuals when I first
get a vehicle ,so I will be ready when the vehicle acts up

A repair shop may print it for you off ALLData of whatever they have

You don't have a short or the ECU would be smoked
3helpful
2answers

Where is the computer box located in a 97 avallon

Instructions
    • 1

      Remove the battery cover to access the battery terminals. Disconnect the negative (-) battery cable with the pliers.

    • 2

      Open the glove box door and squeeze the outer part to remove the door. Locate the two screws behind the door to remove the glove box.

    • Sponsored Links

    • 3

      Access the ECU behind the glove box. Remove the electrical connectors by hand; remove the bolts mounting the ECU to the inner dash.

    • 4

      Install the new ECU in the same position. Replace the bolts and reconnect the electrical connectors.

    • 5

      Replace the glove box and the glove box door. Reconnect your battery.

Sponsored Links

Read more: How to Replace a Toyota Avalon ECU ' eHow.com http://www.ehow.com/how_6170111_replace-toyota-avalon-ecu.html#ixzz289jiGlka
0helpful
1answer

Need wiring layout for raido in 1991 F150

Here are what the different colors do.1991 Ford F150 Truck Car Stereo Wiring Schematic
Car Radio Battery Constant 12v+ Wire: Green/Yellow
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Red or Black
Car Radio Illumination Wire: Blue/Red
Car Stereo Dimmer Wire: Orange/Black
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Green
Left Front Speaker Negative Wire (-): Black/White
Right Front Speaker Positive Wire (+): White/Green
Right Front Speaker Negative Wire (-): Black/White
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Pink/Green
Left Rear Speaker Negative Wire (-): Pink/Blue
Right Rear Speaker Positive Wire (+): Pink/Blue
Right Rear Speaker Negative Wire (-): Green/Orange
0helpful
1answer

I need wire diagram icbm9793

Sorry i cannot help try buying a haynes manual is the best bet but remember that ECU pins and layout is closely guarded secret for dealers only
0helpful
2answers

Swapped a 1999 420A engine into a 1995 eclipse (also a 420A) and we have no spark. We started by checking the cam sensor and it is working properly it is upside down from the 95 but the ASD relay is...

first the cam sensor shouldn't be upside down from the 95. they both should be with the plug facing down. they 95 CAS has a different plug than the 99 CAS.
the 95 has round pins and the 99 has flat pins.

95-96
9f942a5.jpg
--------------------
97-99
ad9a342.jpg
-----------------------------
also the 95-96 relays are opposite the 97-99

95-96
db7e0e0.jpg
------------------------
97-99
c98327d.jpg
---------------------
besides that it could be the ecu. i also have heard of the locating pin on the intake cam shearing off, allowing the gear to turn with the timing belt without the actual camshaft spinning.
1helpful
1answer

Hi I have problem with Chrysler Voyager 2001 3.3l Automatic.The car would turn over from the key,I have checked the ign switch-sends a signal to the starter relay.The PNDR switch is operating,the wiring...

pin 86 and pin 30 at the relay should have power then your right about ground supplied from the ecu and the other goes to the starter solenoid check for battery voltage on those 2 pins 86 and 30 one fuse is under the hood and the other is under the dash.
1helpful
1answer

HORN DIAGRAM FOR A DODGE RAM 1500 (CONNECTIONS)

Battery Constant 12v+ Positive Wire (+): Black/Orange And Red/White
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness
Starter Positive Wire (+): Yellow
Starter Positive Wire Location: Ignition Switch Harness
Ignition Positive Wire (+): Blue (16 Gauge)
Ignition Positive Wire Location: Ignition Switch Harness
Second Ignition Positive Wire (+): Yellow/Red
Second Ignition Positive Wire Location: Ignition Switch Harness
Accessory Positive Wire (+): Blue (10 Gauge)
Accessory Positive Wire Location: Ignition Switch Harness
Second Accessory Positive Wire (+): Orange
Second Accessory Positive Wire Location: Ignition Switch Harness
Parking Light Positive Wire (+): Black/Yellow
Parking Light Positive Wire Location: At Headlight Switch
Power Door Lock Positive Wire (+): Orange/Violet
Power Door Lock Positive Wire Location: In Drivers Kick Panel, White 6-Pin
Power Door Unlock Positive Wire (+): Pink/Violet
Power Door Unlock Positive Wire Location: In Drivers Kick Panel, White 12-Pin
Door Trigger Negative Wire (-): Yellow
Door Trigger Negative Wire Location: At Headlight Switch
Domelight Supervision Wire: Use Door Trigger (Requires Relay)
Domelight Supervision Wire Location: N/A
Horn Negative Wire (-): Black/Red
Horn Negative Wire Location: At Steering Column Harness
Tachometer Wire Negative Wire (-): Gray
Tachometer Wire Negative Wire Location: At PCM, Connector 1, Pin A7. The PCM (powertrain control module) is located on the firewall next to the wiper motor.
Brake Light Positive Wire (+): White/Tan
Brake Light Positive Wire Location: At Switch Above Brake Pedal
Factory Alarm Disarm Wire (-): Black/Orange (To disarm requires a (-) negative through a 1565 ohm resistor and an extra relay to connect.)
Factory Alarm Disarm Wire Location: In Drivers Kick Panel, White 12 Pin Plug
Factory Anti-Theft System: N/A
Factory Anti-Theft System Location: N/A
0helpful
1answer

2007 350z

here it is hope it helps


http://www.innovatemotorsports.com/resources/2003_2005_G35_350z.php

please leave feedback.
cheers
Not finding what you are looking for?

201 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...