The front passenger seat belt is locked and will not retract, how do I access it in order to un jam it?
SOURCE: How do you fix a stuck seatbelt in front seat
this is a simple repair many dont know. remove or pull off plastic pillar post cover, seatbelt probably twisted inside. twist it back around so it runs flat and lube slightly with a light lube spray on metal gearing. i had the same problem w mine pk
SOURCE: mercury sable 2002 serpentine belt change
There are also two serpentine belt types for the 2002 sable. The S and U type engine. Take the old belt with you the the parts store. As for the diagram, I googled it under images and about a dozen correct ones came up. Remember the 2002 sable is the same as the 2002 Tarus.
SOURCE: jammed seat belt
bet the belt is twisted pull back the rubber door seal and remove the top buckle should be possible to remove the trim pull the belt all the way out and untwist go for it
SOURCE: seat belt will not retract. how do i fix it?
The mechanism that allows it to retract is broken. Replace the seat belt.
SOURCE: '06 Volvo V50 drivers seat belt is jammed.
I solved this on my 95 volvo 850 glt as follows:
pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.
good luck and don't give up.
Testimonial: "Thanks, this works! Got to mechanism by taking small hole edge trim off, pushing it upwards released ratchet. No probs since. "
124 views
Usually answered in minutes!
×