2005 explorer, o/d light flashing & check transmission light flashing codes PO732,PO735, & PO775 What do these mean
SOURCE: overdrive transmission
this is the old style transmission code you have a problem with a solenoid inside the transmission go to a transmission shop to read and replace the solenoid only not a rebuild usually
SOURCE: DTC'S PO731.po732, po735
gear 1 ratio incorrect, gear 2 ratio incorrect,gear 5 ratio incorrect
SOURCE: 05 Ford Explorer Transmission
on the bottom of the transmission pan you will find a nut with a hex or torx in the middle you remove the center plug when the truck is hot and running on a level serface the trans fluod will dribble out if it does not dribble out it is low if it runs out fast a steedy streem it is over full now their is a part that screws into this for a fill if you remove the pan you will see how it works the pan has a pipe/ stack that when full of fluid the top of the pipe is at the full point if you remove the large nut the stack and plug will come out the best way to change the trans fluid is take it to some place that has a fluid exchange equment this will get all the fluid out including the torque converter
SOURCE: my check engine light came on and i pulled the
P0732 trans code, if this is a stand alone code, access someone with a chrysler scanner and monitor the trans speed sensors, preferbably the input one, make sure there is a rpm readings on both when you drive the vehicle, if ok, do a 2nd gear clutch test, if failed, internal clutch failure, if ok, replace the trans soleniod pack, it has internal failure, easy to change on this model with the 41TE trans only, if 62TE, take it to a Chrysler dealer.
GOOD LUCK, RDJRP
SOURCE: I have a transmission code PO732, PO734, and
Those three codes point to shift solenoid and/or clutch problems according to the Dodge Service Manual
Find someone with a Chrysler scanner and monitor the trans speed sensors, preferably the input one, make sure there is a rpm readings on both when you drive the vehicle, if ok, do a 2nd gear clutch test, if failed, internal clutch failure, if ok, replace the trans solenoid pack, it has an internal failure
Testimonial: "Thanks for taking the time to leave me some feedback about my issue. Your feedback was very helpful in helping me understand what my issue is. Thanks"
102 views
Usually answered in minutes!
×