Harrington richardson arms - Cars & Trucks

All unsealed roads within Narromine Shire Now CLOSED ALL VEHICLES . ESSENTIAL SERVICE VEHICLES ARE EXEMPT. ROADS REMAIN CLOSED Gainsborough Rd Remains Closed Ellengerah Rd Remains Closed Tomkins Rd Remains Closed Pineview Rd Remains Closed Tyrie North Rd Remains Closed Jamea Rd Remains Closed Richardsons Rd Remains Closed Derribong Rd Remains Closed Belmont Rd Remains Closed Dappo Rd Remains Closed Belowrie Rd at the Momo Rd intersection Remains Closed Momo Rd Remains Closed MR354 The Mcgrane Way NOW CLOSED in both Narromine Shire and Parkes Shire.

stick with the manufacture

Your on the wrong site-- this is for automotive questions

probley the battery is going out if its the factory battery

I have a problem with a 1999 Dodge Intrepid 2.7. Looking for some help or suggestions.

Problem: I only have a spark from the #2 coil.

Background:

Vehicle purchased from an Auction and would not start. The vehicle would only backfire. When I removed the valve covers I found that one of the rocker arms had popped out. I replace the heads with heads from a 2001 Intrepid 2.7. I used the cams, primary and secondary timing chains from the 1999 heads. Not sure if I used the original primary (left) cam sprocket from the 1999 or one I purchased in a kit from a Dodge dealership. I tried to use the new primary timing chain but it was not the same. The replacement heads were surfaced and a new head gasket was used. When I tried to start the vehicle it had no spark. The vehicle had set at several locations and parts may have been removed or changed.

Solutions Tried:

I tried 4 ASD relays with no effect. I then tested all 4 on a 2002 Intrepid 2.7 that runs and all worked. I then discovered that the Crank PS has missing. I replaced the Crank PS with one from a 2002 Intrepid 2.7 with no effect. I then replaced the Crank PS with a Crank PS from a 1999 Intrepid 2.7 and got a spark at the #2 coil only. I then replaced the PCM and TCM from the same 1999 Intrepid I got the Crank PS from and still only have spark from #2 coil. I then changed the Cam PS, still spark only from #2 coil. I have tried several coil packs on connector #2 and all have spark. Each coil pack that sparks on #2 will not spark on any other connector. Spark from #2 coil is weak.

I then replaced the wire harness from the PCM to the coils and fuel injectors and still only have spark from the #2 coil. What am I missing? Any suggestions, advice or related information will be greatly appreciated!

Thanks!

Keith P. Richardson

[email protected]

404-606-0728

no it should not be a problem if the car has been well maintained and in good shape I would not be afraid to buy it

Not sure if you checked or not, but did you check the switch itself? Even though the wipers work with the switch, it can still be bad. If this helps let me know, if not I'll be here for you until it works! Take care and best wishes to you.

Bryon

Try disconnecting the MAF sensor, if the problem clears either clean the MAF with brake clean or replace it, whichever works.