I can not open my passenger door all the hardware has fallen into the side of the door.
SOURCE: mazda 2003 MPV door locks
I just fixed this same problem. It happened to me 3 different times in
a month so I got good at it. Before you dive into removing your door
try this. Pull the door handle and release it letting it snap back
several times. The problem is a half open door latch that won't let the
door unlock. Do this as aggressively as you can to attempt to get the
latch to return to its original position. Check the door lock between
flicks.
Ok, if that didn't work, here is how to remove the door.
1. Remove the screw behind the door latch, you will have to pop the plastic cover off first.
2. Remove the rubber insert in the door handle
3. Remove the screw that is now visible
4.
Now remove the window/lock control module, the back is free but the
front has a plastic lip so lift the back up and pull towards the back
of the van.
5. Remove the clips that attach to the lock and to the window controls (these can be a pain)
5. (Optional) Remove the bracket that held the window/lock control module
At
this point your door is basically free, it is only held in place with
plastic clips that can be easily forced off. If your door were open you
would simple pull the bottom of the door out (hinged at the window) and
lift it off. But since we can't pull because the door is closed we have
to force it out.
From here it is pretty simple. Move the seat
all the way back and tip the seat way back. Lift the door panel
straight up. You will be breaking 2 plastic clips from the rear part
but once you do it just pulls out. This is not that easy because the
space is limited but just keep pulling and force the rear end of the
door panel past the b-pillar. Once you do this it is free.
Have fun and try to keep the black gook from getting everywhere.
Oh, to fix the door lock just oil/grease it and manually move the mechanism several times.
SOURCE: I am trying to replace the low beam bulb on the
Open the 2007 CX-7 Owners Manual (here is you don't have one http://www.mazdausa.com/MusaWeb/pdf/manuals/2007CX7OM.pdf)
Go to page 8-35 (P. 331 in the pdf). Close the hood, you're in the wrong place. Remove the cover in the front of the wheel arch to expose the headlight assembly.
SOURCE: Timing chain broke on a 2007 cx7 w 65K miles
you need to take it to your local dealer and raise a big fuss because this is a known problem and if you yell loud enough you should be able to get this fixed under warranty.
SOURCE: How do I change the bulb in the low beam headlight
Removing the bulb in a CX7 is a real PITA. If replacing the right bulb, turn the steering wheel all the way to the right, or do the opposite for the left side. (or you can opt to remove the entire wheel on the corresponding side) You'll need to remove 3-4 of the fender well clips with a phillips screwdriver being careful not to break them. Once the screws are removed, pry back the wheel well cover to access the back of the headlamp to change the bulb.
547 views
Usually answered in minutes!
×