Tranny switch broke and is out of dash. Can I use a jumper wire to get the tranny back to 2W drive? If so, which two wires should be jumped?
SOURCE: electric seat wont move forward or back on 98 chevy blazer
Tap on the motor while pushing the switch. if this does not work take the motor apart and clean the small brushes that contact the motor shaft 2 total they will have a copper wire attached to them good luck
SOURCE: wont shift to over drive
The reason it won't shift is because that plug isn't plugged in. It goes to the overdrive solenoid and the lock-up converter solenoid. I can likely tell you how to adapt it to make it work. What year is the transmission and what did it come out of? I know they are both A4LD transmissions but I can remember what year Ford changed the A4LD from the two wire connector to the three wire.
SOURCE: 96 Cavalier gurgling noise and a little hard to start
to check level of training fluid warm car up and while engine is running check the dipstick to see if the fluid level is at the top of the area on the stick where the criss cross grooves are, it should say hot or full note wipe stick off at first pull out then recheck it after placing it back in and pulling it back out.
First was the spark plugs set right ?
and the gurgling noise could be a sign that the thermostat is sticking and its most likely the radiator fluid boiling back into the over flow tank if you pop the hood does it stink like radiator fluid and is the over flow tank boiling ?
SOURCE: leaking tranny fluid, automatic 96 jetta gls,
actually, mk3 vw's with auto transmissions cant just be topped off. you have to have it done by a certified tech, or if your mechanically inclined, you can buy a kit to do it. but, the problem is, there are magnetic shavings inside and when you flush it, you may or may not flush them with it, which in turn could be worse.
Testimonial: "Thanks for the help"
82 views
Usually answered in minutes!
×