SOURCE: 1996 crown victoria has no heat
i think it is the heater control valve i think it is mounted on the firewall by the top close to the hood it will have two black 5/8 hoses attached to it check and make sure it still has the cable attached to it before you replace
good luck here is the (how to) for your car
The heater control valve (sometimes called the water flow valve)controls the flow of coolant into the heater core from the engine.
Heater control valves are operated in three basic ways: by cable,thermostat, or vacuum. Cable-operated valves are controlled directlyfrom the heater control lever on the dashboard.
Cable-operated heater valve used to control the flow of water or coolant through the heater core.Thermostatically controlled valves feature a liquid-filled capillarytube located in the discharge air stream off the heater core thatsenses air temperature and modulates the flow of water to maintain aconstant temperature regardless of engine speed or temperature. Mostheater valves utilized on today's car are vacuum operated. These valvesare normally located in the heater hose line or mounted directly in theengine block.
To replace a heater control valve:
CAUTION
Identify the heater control valve carefully. It is easily confused with other parts.
SOURCE: emergency brake locked after pull release handle
handbrake jammed on somewhere ,could be front cable ,because the rear cable is pulled by the compensator so if it was the rear one then i would expect only one cable siezed and that is normally the kerbside one.
SOURCE: my driver side door wont lock
The actuator that locks the door is probably worn out. I would simply lock it manually .
If you desire to , you can replace the actuator by removing the interior trim panel and drilling the rivets holding the actuator in the door. Replace the rivets with small screw/bolt combos .
109 views
Usually answered in minutes!
×