SWAPPING ENGINE IN FORD RANGER 2.3 WITH MAZDA 2300 CRANK SENSOR PLUG DIFFERENT HOW TO FIX
SOURCE: 2002 bora pd engine glow plug light is flashing
most likely bad glow plugs and wire harness. take a test light attach to positve side of battery and touch the top of the glow plug see the one that does not light the test light up is your bad one then look in the harness at the connectors if the are dull and not shiney you will need to replace the harness just take the harness and cut and **** connect them together it is easier than running to ecm. good luck. also check you air filter make sure it is not clogged.
SOURCE: I have a 97 pontiac sunfire swapped motors with a
As long as the 96 one looks the same as the 97 and fits properly.
Testimonial: "thanks for getting back so soon I will check them out thanks agian "
SOURCE: 96 ford ranger. swapped engines and now the check
I'm inclined to believe that it would be good, from a troubleshooting point of view, to have the PCM fromt he truck that the new motor came out of, to get hte EPROM.
What are the codes for the engine now that you swapped engines?
I would at least try to erase codes with a scanner, to see which codes come back.
Testimonial: "fast response good info"
SOURCE: I need to swap an engine from a 1992 ford ranger
everything will need to be changed. ECU, wiring harness, radiator, mounts, and too many other things
SOURCE: Engine runs then suddenly dies.Replaced crank
is the cat plugged? if unknown buy or make a test pipe to see if that's it.
58 views
Usually answered in minutes!
×