Changing headlights on hyundai acent 1997

If all the brake lights come on ( including high mount ) with the headlights there is most likely a short somewhere. Have any of the park/brake light bulbs been changed recently. If so a bulb may be installed incorrectly or the wrong bulb application used.

Check the bulbs could be blown low beam

Hi ,Check the light bulb,see if its seat in the seats properly 'for earth' and the light terminals for dirts ,grease,or corrosion.clean if needs to.I think its a Earth problems

Was the car doing this before? If not the filter is directional meaning goes in one side and out the other. Usualy marked with an arrow or in and out. Make sure it is hooked up correctly will cause problems if the gas is trying to go through the filter in the wrong direction.

Here is the only literature I could find to help you. It is located in the Hyundai Accent Owners Manual under "Do It Yourself Maintenance" The shop manual doesn't even list the headlamp bulb, let alone tell you how to change it. Apparently, it is so simple to change, that they did not feel the need to explain it much.

once you pop the hood, there should be a cover behind the light housing that you twist to open the backing.. inside the housing will be a spring lever that secures the bulb down... unhook the spring and disconnect the harness connecting to the bulb...

You have to change the flexy pipe.The lambda sensor is behind that.And its the sensor that is giving you the problems by not getting the correct readings from the exhaust gasses.

http://www.hmaservice.com/.. register. Lots of shop manuals, wiring diagrams, etc.

Some imports require the entire light assembly to be removed in order to replace headlamps. Look to see if there are angled rods on the back side of the light assembly. If so, see if the can be pulled straight up towards the hood of the car. When they are released the headlight will be able to come forward. Good luck. Hope this helps.

7 litres.... but keep in mind that's with the torque converter dry. so just keep adding fluid and checking the dipstick level.