Car won't start

Have you checked the wiring, the spark @ plug, Power to the coil???

Engine Won't Start No Spark - Auto Diagnosis Repair Help

aa1car.com/library/no_spark.htm

If your engine cranks normally but will not start because it has no spark, or it ... If an engine has a coil-on-plug ignition system with no plug wires, remove one of ...

No-start, No-Spark diagnosing simulated - YouTube

? 5:13
https://www.youtube.com/watch?v=XSWN1M8Hoqo
May 19, 2010 - Uploaded by FrankHurtAuto
Simulation of no start with no spark diagnosing, ... Ignition coiland module test with test light (ScannerDanner Premium lecture) - Duration: ...

getting fire from coil but not to plugs - CarGurus

www.cargurus.com > Questions > Dodge > Ram 1500

CarGurusJun 12, 2013 - 2000 dodge ram 1500 4x4 not getting fire changed distributor cap, coil, pickup ignition, rotor, plugs, plug wires 2 answers. ... 1994 dodge 5.9 just shut off and wont start back up there is no spark or fire from coil or plugs. ... 94 dodge van 318 eng will not start new plugs new crank ...

Ignition Coil Troubleshooting: (No) Fire in the Hole

www.secondchancegarage.com/public/coil-troubleshooting.cfm

Replace spark plugs as they might have been worn and check the specific gravity of the battery checked. The ignition coil also may be causing the problem.

well if ur not getting spark and u changed all of the ignition components lets think about the computer in order for the ignition to work you have crankshaft position sensor that fires the fuel injectors and the spark change that and if still nothing then change the camshaft postion sensor that sensor tells the computer that the 1 piston has came all the way up and it tells the crankshaft sensor to do its thing

1. The ignition system on your 5.0L uses a distributor type system and will include the following components:
   1. Ignition control module (ICM). Depending on the year of your specific Ford, it'll have a inner-fender mounted ignition control module or a distributor mounted ignition control module. hot sure which you have.
   2. Ignition coil. you replaced it.
   3. PIP (Profile Ignition Pickup) sensor. This is Ford's name for the crank sensor and is mounted inside the distributor. The most common name for this component is the pick up coil.
   4. Distributor cap and rotor. you replaced
   5. Spark plug wires. you replaced.
2. The thing to keep in mind about the ignition system is that all engine cylinders must get spark and the one thing that will stop the ignition system from creating spark on a wholesale scale is a BAD crank sensor.Have you pulled a plug then using some insulated pliers grounded it to the vehicle and turned it over to see if you have spark, that'll tell you alot.takes two people of course.Best of luck and hope this helps.

Check all of the new wires especially the coil wire to see that none are loose. You may need to have the coil checked for spark.

If there is spark but not getting to spark plug, chances are the crank sensor malfunction.

check engine light is probly burned out, bad coil

An ignition module tells the coil packs when to spark. Autozones can test ignition modules for free. (helps them make a sale)

Check for spark at any of the sparkplugs.If there is no spark at the plug then replace the distributor ignition pickup coil.