Drivers side door window and seat controls not working
SOURCE: I have a 2004 GMC
Remove the Positive Battery Terminal, leave the Negative Terminal connected. Wait 30 minutes. Attach the Positive Terminal. Verify temperature settings is around 70 degrees. This procedure has been known to resolve computer settings.
SOURCE: HAVE A 03 GMC SIERRA
I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.
SOURCE: drivers side window control cluster
The control may have gone bad... You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then you can disconnect the controls and test them
SOURCE: Air conditioner blows hot air after 30 seconds on
I have had this problem. I am not a mechanic...so to correct the issue temporarily, I simply turn off the car and restart. This has worked everytime for me. In extreme cases, I think you can also remove the AC fuse and start the car, which will also reset the computer. I also think that by taking the climate control off the "AUTO" setting has worked in the past.
SOURCE: Heated seats won't stay on in 2004 GMC Yukon Denali
See GM TSB 05-08-143-001, If you have Adjustable pedals, especially if they don't work with the memeory buttons, but function with thier own buttons. Its the Brake Pedal Position Sensor is shorted and mesing up the seat module which controls the heaters too. My 05 Suburban had the same issue
535 views
Usually answered in minutes!
×