SOURCE: idle at 1500 to 2000 rpm
Most likely the throttle body gasket (between the throttle body and the intake manifold) is leaking.
SOURCE: engine stalls after cold start-up & release from high speed idle
I had a similar problem. I found the filter cartridge below the pcv valve had carboned up, and after the crank case pressurized, oil was forced out the pcv supply line to the throttle body. The idle air control valve solenoid got oil in it and caused my problem, but only when it was cold. The pcv cartridge is accessed by removing the pcv valve and the rubber fitting that the pcv valve mounts in. It can then be fished out with a pick set, and it is a pain because you can't see it, but you can get you hand back there. I hope this helps you.
SOURCE: 02 Grand Cherokee High RPM start. Cuts out when driving
Ckean throttle plate inside throttle body...They tend to get dirtier than their counterparts in carbureted engines due to lack of fuel spray that kept them clean. If no luck with that, clean idle air control valve on TB. When doing this, don't turn the plunger, just clean with carb spray and replace. do not loose "o" ring seal.
Good luck
SOURCE: engine starts,reaches high rpm,then slowly returns
Vacuum leaks. Check all hoses and intake bolts. Leaking EGR or plugged PCV valve. Air filter plugged. Leaking head gasket. Worn timing chain. Camshaft lobes worn. Valves burned or leaking. Fuel idle control system or sensor. Good luck!
SOURCE: 1995 k2500 suburban idle too fast
replace the coolant temp sensor,it`s values are off,it is defective.Also if this does not work,witch I think It will,change the throttle position sensor.
132 views
Usually answered in minutes!
×