SOURCE: 98 chevy s10 blazer turn signal
Unplug the turn signal relay from the fuse box and start you engine. Does it still make that noise?
If yes... Put the relay back in, that is not the problem.
If No...Then the relay could be bad, replace it!
PLEASE RATE THIS SOLUTION! Thank You Very Much!
SOURCE: gm passlock security system how to disable
Wiring diagrams can be found online, however i believe you can re-learn the key by leaving it inside the ignition tumblen and switch it to accesory. Then disconnect the b attery for about ten minutes and then try starting the car without taking the key out.
SOURCE: theft system passlock on 2003 chevy malibu. theft
yr gonna have to get the passlock key and punch it into the radio so u can solve ur problem most chevy dealships can assist you with that.
SOURCE: I have a 2002 Chevy Avalanche, that the battery
if your security light is on it won't start. Leave the key for tens minutes or so until the security light flashes then it should start.
SOURCE: pass lock problems
Your Passlock may need to relearn the ignition keys, if the
ignition lock has gone bad like my in-laws Grand Am Gt, here is what i
did so they will not get stranded any more. Buy a Passlock by pass
module for around $70.00. You can order one from GMPASSLOCK.COM in the
mean time try resetting the Passlock. Good luck
Ignition keys relearn takes about 30 min to do. 30-Minute Learn Procedure
1.) Turn ON the ignition, with the engine OFF.
2.) Attempt to start the engine, then release the key to ON; the vehicle will not start.
3.) Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF.
4.) Turn OFF the ignition switch, and wait 5 seconds.
5.) Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes.
The vehicle is now ready to relearn the Passlock
Sensor Data Code and/or passwords on the next ignition switch turn from
OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle
learns the Passlock Sensor Data Code and/or password on the
next ignition switch transition from OFF to CRANK. You must turn the
ignition OFF before attempting to start the vehicle.
6.) Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password.
7.) With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.
Without a scan tool you may have momentary starter interruptions while history clears itself.
115 views
Usually answered in minutes!
×