Question about Cars & Trucks

1 Answer

Kia picanto 2005 the car won't go into gear when engine is turned on ? Happened after I had to bump start the car

Posted by on

  • Jerry Jan 31, 2017

    If the clutch is hydraulic, check for any leaks. Check the level of hydraulic fluid in the clutch master cylinder. Top it up if low and bleed the system. Remember if the level is low it indicates a leak somewhere. Or if it's a cable. See if there's any way of adjusting it. Some clutch cables auto adjust. Based on a ratchet design. It this don't improve or solve your problem. You will unfortunately have to replace your clutch kit.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 256 Answers

You killed the tranmissision in it , Have a nice bill for your (Screwup)

Posted on Dec 07, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 64 Answers

SOURCE: 2007 kia picanto hard to start in the morning.got

Hi, this might be because of a voltage drop on the cables or the battery needing replacement. The colder the weather the more current your starter will braw. You can check for a voltage accross the bateery by connecting a volt meter to the battery and crank it if the voltage drop below 9.6V your battery might need replacement, if not you will need to see what the voltage drop is on the solenoid. You should have battery power on the terminal that activates the solenoid in order to get the solenoid to energise. If you do not have battery voltage on that terminal I suggest putting a relay between the ignition switch and the starter or replacing the wiring harness between the 2. Also check the connection on the ignition switch itself as you can get a bad connection there to.

Posted on Jan 21, 2010

  • 77 Answers

SOURCE: check engine light on car dies when I touch brake

Check Engine light is on. Find out what DTC (diagnostic trouble code) is set and I can help you more. You can get a code puller from your local parts store.

Posted on Feb 01, 2010

  • 4793 Answers

SOURCE: How do you bypass the immobilizer on a Kia

YOU CANNOT BYPASS THE SYSTEM,You must have the remotes recoded by a dealer.if you have the book try and reset the alarm.if not ask another question on this site and we will get back.

Posted on Jan 29, 2011

Testimonial: "Thanks Goeffreyh"

jas0518
  • 130 Answers

SOURCE: car starts, then Shuts off.

is your security light flashing on the dash when this happens?

Posted on May 30, 2011

  • 2 Answers

SOURCE: 2005 Chevy Equinox P0742 & P0700 problems. My

2005 Equinox's are known for water leakage problems around the cowl and windshield areas. Water leaks in and causes shorts in the main wiring harness and eventual corrosion between the fuse panel's grounding to the floor under the shifter console. Reroute a new ground wire to the body from the fuse panel in the shift console. Find the source of water leak. GM paid to have mine fixed.

Posted on Dec 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove wing mirror cover drivers side from a 2005 Kia Picanto LX


kia-rio-side-mirror removal-04 - atomia.ir - YouTube

? 0:25
www.youtube.com/watch?v=GWIcTycQFYI
Feb 16, 2013 - Uploaded by Arash Soltani
rio-side-mirror removal-04 - atomia.ir. ... Drivers Side MirrorReplacement ' Kia Sedona ' Other Makes ...

Kia Picanto Forum [Archive] - Kia Forum - Kia-Forums.com

www.kia-forums.com > Kia Forum > KIA Models
[Archive] Life is more colourful with Picanto. ... Picanto 2007 auto transmission abrupt start problem · Driver side door lock problem (2005 picanto) · Picanto 1.0 lx ...

Oct 14, 2015 | Kia Cars & Trucks

1 Answer

Kia picanto problems


explain more in detail what the car is doing.is the starter turning the motor and it wont start,or is the starter not turning.

Aug 20, 2014 | 2005 Kia Picanto 1.1

1 Answer

WHY kia picanto auto move slowly if put in gear d


clutch slipping could have worn pressure plate or clutch plate. could have oil leaking from rear main oil seal getting on clutch plate causing slipping.

Jun 16, 2013 | 2005 Kia Picanto

2 Answers

Kia picanto 1100 starts but doesnt want to rev up


Hi,there is a common fault on these cars,that is the cranksharft snaps just behind the crank timing gear,this causing the ignition timing to run at minus and thus the car gets spark after petrol has been injected.the car will run rich and also damage the plugs.the pick up sensor can also be faulty.this can all be checked by taking the bottom cover off and checking,except the sensor has to be checked with diagnostis scanner.most likely it is the broken crank.if u in the Durban area I can help you.

Apr 11, 2013 | 2005 Kia Picanto 1.1

1 Answer

Can an engine rev when cambelt is taken off?


Hi

To answer your question directly......NO, the engine can not rev when the cambelt is removed, it won't even start. This is virtually impossible for any 4 stroke engine.

i will explain why....... The cambelt connects your camshaft with your crankshaft, when the engine was assembled, the camshaft and crankshaft was turned on the correct alignment marks and the cambelt was fitted. These marks on the cam and crankshaft allows the 4 strokes to happen at the correct time(intake stroke,compression stroke, power stroke and exhaust stroke) If the cambelt had to be removed, there will be serious damage done to your engine, in the first place, the car will not start if the cambelt was removed. the correlation between your camshaft and crankshaft will not correspond and the pistons will hit and damage the valves.

I hope the above description will help you.

Mar 25, 2013 | 2005 Kia Picanto

1 Answer

Engine turns over but won't start


Have you checked if it is fuel or spark related? Did it die while you were driving it? When did it happen? Does it have gas? I know that sounds dumb, but stranger simplier thing have happened. Timing chain?, Distributer gear worn due to worn cam? fuel pump?

Feb 10, 2013 | 2005 Chevrolet Silverado

1 Answer

How to disable alarm on kia picanto


don't think so and batteries are CHEAP

Dec 18, 2012 | 2005 Kia Picanto 1.1

1 Answer

2005 1.0 kia picanto cel flickering wont start


Try to scan it and retrieve code from check engine light it could cause so many things. You need to start from tehere to reveal code.

Feb 06, 2012 | 2005 Kia Picanto

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...