What to connect the red wire to when replacing headlight assembly in mercedes 400e 1992

SOURCE: 1992 Subaru Loyale headlight condensation

the only way to get the water out isto drill a hole in the bottom of the headlight assemly. they don't come apart. drill very slowly.

hope this helps
please rate well.

If you need further help, reach me via phone at https://www.6ya.com/expert/mark_445a24324be9eb03

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: REAR KNOCKING NOISE, 1992 400E MERCEDES

hello,it"s hard to tell,maybe visual check in your hood or trunk mounting if there is a loose welding or crank in body,or lift your car,visual check on rear suspension bushing,rear wheel bearing,propeller shaft bearing,ty

SOURCE: 1992 mercedes benz 400e

It is a straight forward procedure, but getting it around the fan is tight. Just put a wrench on the belt tensioner pulley, and pull up on it to loosen the belt. While holding the tensioner up, slip the belt off. Just make sure you draw a diagram of the belt routing, before taking it off.

Greg Bernett

• 2993 Answers
• Posted on Oct 12, 2009

SOURCE: where is that fuel filter

Removal & Installation Two types of filters are used, depending on the vehicle. Both are located between the rear axle and the fuel tank.

1. Disconnect the negative battery cable.
   
2. Unscrew the cover box.
   

1. Remove the gas cap, fuel pump cover and pressure hoses.
   
2. Loosen the screws and remove the filter. Remove the connecting plug from the old filter and install it on a new filter using a new gasket.
   

1. Install a new filter in the direction of flow. Always replace the copper gaskets.
   
2. Replace the attaching screws.
   
3. Install the pressure hoses, pump cover and gas cap. Torque the banjo fittings to 80 inch lbs. (9 Nm).
   
4. Install the fuel filter in the holder by positioning it in the center of the transparent holder. Be sure the plastic sleeve between the fuel filter and fuel pump is installed. Galvanic corrosion may occur in cases of direct contact between these components.
   
5. Replace the cover box and check for proper sealing.
   

SOURCE: Headlight repair on 2003 Mercedes Benz E320

how do you change left low beam bulb on 2003 mercedes e320