SOURCE: How to program a keyless remote transmitter fot
the only way to program the remotes is with a scan tool that the dealer has
SOURCE: abs light
the sensors for the ABS are on each wheel, it is a geared wheel which sends pulses to the computer from a magnetic coil in close proximity to the gear.....sometimes debris from the road or old brake lining foul up the gear...that causes the magnet to not put out any pulses. your computer then sends a signal indicating a fault because of no signal condition.....solution.....check and clean debris from ABS gear. if this fails....check for bad or corroded or broken wires from magnet to computer....I mean continuity......also bad grounds cause many different problems in autos...so it's also a good idea to check for bad grounds....good luck
silvio
SOURCE: headlight and horn problem on 1996 saturn wagon
This may or may not be related, but....I just spent numerous hours on my daughters 1999 SC1 for it was "arming" the security system, and wouldn't start. This was irratic and would come and go. Today I discovered that moving around the wiring that goes to the center console fuse block would make the interior light go on and off. I was losing power to four fuses, one being the "chime" fuse. I had to remove the console, all of the fuses and relays to get the fuse block out and apart. It's like layers. The final result was a power wire connection that was opened up and loose on the terminal that feeds the fuses. You could see a little melted plastic around the connection. I think this may be a problem for saturns. I just tightened the connection, cleaned it and off we go. Hope this may help.
66 views
Usually answered in minutes!
×