Programmed key ncar starts eeded?
SOURCE: key stuck in ignition but it will turn, and
you most likely have a bad key switch cylinder assembly. you can try to spray wd40 solvent into the switch before you have the switch replaced,but sometimes it's a switch replacement that repairs the problem. have you inspected your ignition key to look for damage to the key itself? try a spare key to make sure it's the key,and not the key switch. you can also try turning the key while turning the steering wheel at the same time to get the key to work.sometimes the switch locks when parked in a bind,such as on a hill,or against a curb and so on. try this 1st before you have the ignition switch replaced. AAA auto club,if you're a member covers part of the replacement costs for a replacement switch also. you may have coverage through a cell phone also.one more thing to try, if you have a tilt steering column,try to reposition the steering wheel to see if you can get the key to turn. remember never force it enough to break your key off into the switch! thank you for choosing fixya.com!
SOURCE: when I try to start
If any of the gauges are blinking and going haywire and the security light flashing then the instument cluster is faulty.But if it is just the security light flashing then its in the switch.If you only had the switch replaced then you need a new ignition lock cylinder because its worn out.
SOURCE: I have a Lincoln town car1998 my Car won't start i
You say t pump is coming on, but do you fuel coming up to the fuel injector rail? You can check for fuel by pushing down the valve located at the left front side of fuel rail. It looks like a tire air fill stem. Be very careful as fuel is under 40 psi pressure and can spray all over the place. do this with engine OFF and have a rag to cover the valve. Just press with tip of screwdriver and be sure valve is covered. If a little gas come out,you know you have fuel. If not gas then check fuel delivery system i.e pump, filter, lines or pickup tube.
If there is fuel in the rail, then there is most likely a problem with the control module (computer).
Check for fault codes with an OBD II reader. You can usually rent one at your local part store. You can look up fault codes to find out where the problem might lie.
More questions, just leave in comments.
Good Luck.
J
Thanks for using FixYa!! I provide my answer for free as a public service - a 4 THUMBS rating and POSITIVE Comment is really appreciated for the FREE answering of your question.
LtCmdr
Spock said: "An ancestor of mine maintained, that if you eliminate the
impossible, whatever remains, however improbable, must be the truth."
SOURCE: My car sometimes won't let
This is probably the ignition lock cylinder worn out or getting old. The TDM is most likely not locking the key in, but new cars are pretty tied into themselves. For now, just try leaving the key in. Use another one for the doors. Some cars have a small hole under the steering wheel/column that you can stick a pen or something in to release your key. Maybe just be ready for something else breaks, then you'll know what is wrong.
http://vatspasslockpasskeysecurityhelp.yolasite.com/
SOURCE: electronic key on 2008 jeep
electronic key on 2008 jeep cherokee says key damaged or key not programmed. car won't start. some things work but radio won't come on. etc..
92 views
Usually answered in minutes!
×