I purchased a used 2001 Chrysler Voyager from an elderly man that said he didn't know if the radio worked. It doesn't. The display doesn't come on but when I first turn the key on, I hear a "pfft" over the speakers and nothing else. I checked the fuses under the hood, pulled the radio out and all looks well with the exception of one wire(white with red) that doesn't seem to attach anywhere. Please help! I hope I won't need to buy another one.

SOURCE: chrysler 2000 grand voyager The fans under the

You either have a bad relay, bad temp sensor, or bad PCM. I would start with the relay as these give the most problems.

SOURCE: Audi 2001 A4 Symphony Radio Issue.

check for constant power
ground
and ignition power
also if you have power factory amp may be you problem if power and no sound

SOURCE: wiring schematic for plymouth grand voyager 1995

Is there green corosion on the tip of the wire ? Chances are the answer is yes. You will have to detach the fuse panel/box and run a new wire and connector to the fuse panel. Splice into the wire you can see, but make sur you cut enough of the wire off to get rid of the corrosion.Hope this helps.

SOURCE: 91 accord when turn key to start NOTHING

it could be your starter or ignition switch.
to check it you need a test light and another person
connect the test light to a good ground
touch the test light to a big terminal on the starter it should have power
touch the smaller terminal and have the other person starts the engine
you should have power while the engine being started, if not then the problem is in the switch. if you have power then starter is bad

Testimonial: "i'd like thank you very much,,,come day light family is going to do as you advised.. "

SOURCE: I have a 1995 Buick LeSabre that won't start.

This is related to GM's VATS security system. It treats sudden loss of power as an attempt to steal the car. To reset the system, do the following: courtesy of ***** Master ASE Technician

• Use your key fob (if equipped) or key to unlock the doors.
• Turn the key to the start position and release it
• Leave key in the ON position for 10 minutes.(the security light should go out at this time
• Turn the key to the OFF position for 10 seconds