No heating in my ford focus car .

probably just the light itself has burned out the light should be cheap under 10.00 but there are might be a few panels you have to take off to get to it, and will probably break a few plastic hangers as well but those are pretty cheap as well. I do recommend buying a decent interior panel pliers. they make things so much easier.

Hi,i had similar problem,the fan wasn't working.When i turned heater on hot it released the heat from the engine & temperature went back down.Turned out my fan relay fuse had blown.$5 fixed the problem.Hope this helps.

winshield or engine pre-heater?

Sounds like a burned resistor for your fan speed. 2- 8mm screws removes resistor check to insure coils are not broke.

look under the dash for a big black box the fan will be in that box but first check the wires for good connections and power

your damper doors are not closing in the box itself properly and also you need to check the flow rate trhough the heater core its highly possible the heater core is possibly clogged with dirt and debrise' sometimes you can just reverse the ehater hoses and drive the vehicle for a few hours or even days and that bach flushes the dirt out of the core then you will need to drian your radiator and refill with clean antifreeze

cable corroded up ,thats all so its getting stiff like my joints with old age

tak the glove box off you should see a bin shaped plastic cover underneath this there are 3 screws take them out the motor will *** out it is in a plastic cup its self un plug it make sure its not seized ggrease it up free it up then get a 12 volt battery and connect it to your motor if it dont spin its junk if it dose put it back in if your heating still dont work it will be your resister which is on the side of the bin 1 screw holding that in replace that if it still dose not work could be the heater switches or wiring lumes

re-charge the battery to full then disconnect it then take the face cover off of the dials then fildle with the dials and make sure its not bent and see if it moves by your hand pushin it over if it does then just pull the pointer on the dial away from the dial itself then put the face cover back on the dials and they should work if not go to this page and consider buying it!!!!

http://cgi.ebay.co.uk/SILVER-LOCKWOOD-Ford-Focus-Mk1-Dial-Kit-98-02-NEW-Dials_W0QQ
itemZ370113210597QQcmdZViewItemQQimsxZ20081115?IMSfp=TL081115119003r8178

thanks kinger!!