SOURCE: Eagle Vision overheating
look for bleeder screw on thermostat housing or front middle of intake manifold area.open bleeder while vehicle running bleed air out.
SOURCE: changing fuel pump
ON most vehicles its inside the gas tank. Siphon all the gas out if possible, put a few jacks under the car and undo straps holding gas tank. Gently lower tank with jacks and take out pump and replace. Its not too hard but having an extra person to help manage the tank would be really helpful.
SOURCE: where is the starter on the 1995 eagle vision
It is well buried. You will find the tail end of it just above and rearward of the driver's side motor mount. It is fastene to the trans bell housing. There is probably a trans line support bracket/plate you will need to remove usually mounted to the middle stud. Be sure to disconnect the battery before you start because the cable is connected directly to battery. There also should be a shim plate between the nose mounting and transmission bell housing. That shim can be a pain but it does prevent premature wear to the flywheel ring gear. (it only fits one way) Those starter solonoids are a common failure item. (only gives a click, or sometimes not even that, when trying to crank.) Let me know if this is helpful
139 views
Usually answered in minutes!
×