Victor Scarpita posted an answer for this Amana AMH95 - 90,000 BTU - Gas-Fired Furnace - NG - 96.1% AFUE - Two-Stage - Upflow/Horizontal - Multi-Speed:
"BURNED MOTOR."
Victor Scarpita posted an answer for this Goodman Manufacturing GMVC951155DX 95% AFUE Two-Stage, Variable Speed, Upflow Gas Furnace - 113,000 BTU:
"I WOULD CHECK THAT YOUR PVC PIPING IS SEALED PROPERLY."
Victor Scarpita posted an answer for this Heating & Cooling:
"MOTOR WOULD JUST GET REPLACED, COST WOULD VARY DEPENDING ON YOUR AREA AND TYPICALLY 3 TO 4..."
Victor Scarpita posted an answer for this Ruud Rheem Furnace Blower Motor 51-17129-01/02:
"COULD BE EITHER THE ONLY WAY TO CHECK IS CHECK THE CAP IF BAD REPLACE IT, IF GOOD TEST..."
Victor Scarpita posted an answer for this Heating & Cooling:
"YOU WOULD NEED FLAME AND FAN, AND SHOULD STAY ON FOR A MINIMUM 10 PLUS MINUTES."
Victor Scarpita posted an answer for this Cars & Trucks:
"WHAT ARE YOU TRYING TO REPLACE?"
Victor Scarpita posted an answer for this 2003 Honda Odyssey:
"Flush the radiator?"
Victor Scarpita posted an answer for this 1997 Honda Odyssey:
"sounds like lifter noise, when is not due to mechanical problem it can be solved using a..."
Victor Scarpita posted an answer for this 1990 Honda Civic:
"can you hear the starter engaging?"
Victor Scarpita posted an answer for this 1987 Honda Prelude:
"timing, vacuum leak, or compression in engine gone!"
Victor Scarpita posted an answer for this 1990 Honda Accord:
"I suspect some check for the O2 sensor, you are either running to rich and the message is..."
Victor Scarpita posted an answer for this 1991 Honda Accord:
"there would be 2 hoses going toward the passenger side/feet area supply and return one..."
Victor Scarpita posted an answer for this 1999 Honda Accord:
"linkage that connects the motor to the arms, stripped or loose."
Victor Scarpita posted an answer for this 2008 Honda Accord:
"I would check all fuses to see if any have blown."
Victor Scarpita posted an answer for this 1991 Honda Civic:
"perhaps the suction from the pump to the tank needs to be primed, fill suction line with..."
Victor Scarpita posted an answer for this Honda Cars & Trucks:
"check the coolant level (when cold only) :)!"
Victor Scarpita posted an answer for this 2004 Chrysler Sebring:
"easiest and best check is stop @ auto zone they'll scan for free once fixed disconnect..."
Victor Scarpita posted an answer for this Cars & Trucks:
"may have something to do with timing advance or vacuum since it happens when you rev it..."
Victor Scarpita posted an answer for this Honda Cars & Trucks:
"I would check alternator, does the car stay running if you unplug the battery + after..."
Victor Scarpita posted an answer for this GE 1/3 Hp Furnace Blower Motor 5kcp39ggu011s:
"MOST UNITS HAVE KNOCK OUT WHERE THE POWER GETS HOOKED UP, HANDY BOX WITH A SWITCH NEED TO..."
Victor Scarpita posted an answer for this Heating & Cooling:
"IT SOUNDS LIKE THE FAN CYCLE RELAY OR BOARD IS NOT MAKING THE FAN COME ON WHEN IT SHOULD..."
Victor Scarpita posted an answer for this 2001 Oldsmobile Aurora:
"I would check your connections @ the servo (box connected to the throttle body by a cable..."
Victor Scarpita posted an answer for this Heating & Cooling:
"CHECK VOLTAGE SUPPLY TO IGNITOR."
Victor Scarpita posted an answer for this Bryant Heating & Cooling:
"MOST LIKELY THE THERMO-COUPLE."
Victor Scarpita posted an answer for this Heating & Cooling:
"MOTOR OVERHEATING, OR FAN MOTOR RELAY."
Victor Scarpita posted an answer for this Heating & Cooling:
"IS NOT THE IGNITION COIL THE MACHINE IS GETTING HOT! SOUNDS LIKE A CERTAIN SPEED WINDING..."
Victor Scarpita posted an answer for this Heating & Cooling:
"Sounds like the flame sensor may not sending a signal back to the controller. clean the..."
Victor Scarpita posted an answer for this Heating & Cooling:
"open inlet @ the inyector and once it starts coming out, quickly connect back on."
Victor Scarpita posted an answer for this Heating & Cooling:
"are the circulator pumps coming on, have you tryed bleeding the system?"
Victor Scarpita posted an answer for this Heating & Cooling:
"then condition is still there, try to find the flue sensor and determin if it is stuck..."