1just in it to win it
Anonymous posted a question about KTM Motorcycles:
"I have a ktm 525xc I did a carb clean the atv started right up and run good yesterday now..."
Anonymous
Anonymous posted an answer for this 2004 kawasaki KX 125:
"bought a bike from someone who said they just put a new wiseco piston and rings in. I..."
AnonymousAnonymous posted an answer for this 2004 kawasaki KX 125:
"sounds like u have a crank seal going bad sometimes you can put the old one back in place..."
AnonymousAnonymous posted an answer for this Yamaha Motorcycles:
"replace the voltage reg sounds like its putting out to much for the light to handle"
AnonymousAnonymous posted an answer for this Yamaha Motorcycles:
"2006 wr 450=cant keep head lights bulbs in.....voltage is spiking"
Anonymous
Anonymous posted an answer for this 2003 Honda CRF 150 F:
"If the chain is loose then you need to replace the chain the adjuster is automatic so you..."
AnonymousAnonymous posted an answer for this 2003 Honda CRF 150 F:
"I got a crf100 05 and is wondering how to tighten the timing chain because it is loose?"
Anonymous
Anonymous posted an answer for this 2005 kawasaki KX 125:
"My 2005 Kawasaki KX 125 was running fine, went riding came home and went to ride today and..."
AnonymousAnonymous posted an answer for this 2005 kawasaki KX 125:
"change the plug then drain the carb and ck compression and that will tell u the story"
Anonymous
Anonymous posted an answer for this 1991 Honda XR 600 R:
"ck the kill switch when they go bad it will short the ig system to ground and you get no..."
AnonymousAnonymous posted an answer for this 1991 Honda XR 600 R:
"No fire from spark plug wire w/test light"
Anonymous
Anonymous posted an answer for this 2003 Suzuki DR-Z 125 L:
"the intake is set at .004 and ex is .006"
AnonymousAnonymous posted an answer for this 2003 Suzuki DR-Z 125 L:
"what are the valve specs for a 2003 suzuki drz 125"
Anonymous
Anonymous posted an answer for this 2002 Yamaha YZ 426 F:
"I have a yz426 and I replaced the timing chain worn. the problem is I can not remember the..."
AnonymousAnonymous posted an answer for this 2002 Yamaha YZ 426 F:
"the cams should face 10 and 3 with a 15 pin count on the cam chain pins from top marks on..."
AnonymousAnonymous posted an answer for this Yamaha Motorcycles:
"timing marks for 2007 yz450f"
AnonymousAnonymous posted an answer for this Yamaha Motorcycles:
"when u set the bottom timing mark on the T mark set the ex cam with mark first level with..."
Anonymous
Anonymous posted an answer for this 2003 Yamaha YZ 450 F:
"03 yamaha warrior has gas and spark but wont start"
AnonymousAnonymous posted an answer for this 2003 Yamaha YZ 450 F:
"ck the Exhaust valve sometimes it will tighten up after someone dose a adjustment in some..."
AnonymousAnonymous posted an answer for this kawasaki Motorcycles:
"make sure the the engine is at tdc take the two cams and set the in the holder at the at a..."
AnonymousAnonymous posted an answer for this kawasaki Motorcycles:
"just changed valve shims and need toknow how to set timing"
Anonymous
Anonymous posted an answer for this 1998 kawasaki KLX 300:
"1997 Kawasaki KLX 300 how to set valve clearance"
AnonymousAnonymous posted an answer for this 1998 kawasaki KLX 300:
"Turn the motor to top dead center and ck the timming marks to make sure you are at the tdc..."
Anonymous
Anonymous posted an answer for this 1995 kawasaki VN 800 A Vulcan:
"sounds like the bike is running out fuel the pump is not holding pressure it may be a..."
AnonymousAnonymous posted an answer for this 1995 kawasaki VN 800 A Vulcan:
"my bike will start but after a few miles dies and won't start again"
Anonymous
Anonymous posted an answer for this 2008 kawasaki Ninja 250R:
"If It was my bike I would first replace the side stand switch and the clutch lever switch...."
AnonymousAnonymous posted an answer for this 2008 kawasaki Ninja 250R:
"i have a 08 ninja 250R and it wont start some times. and some times i have to pull in the..."
AnonymousAnonymous posted a question about Yamaha Motorcycles:
"I have a 660 raptor I have cleaned the carbs and the bike will idle with tunning or run..."
AnonymousAnonymous posted an answer for this kawasaki Motorcycles:
"Sounds like the side stand switch has a short or the n switch is not making a good contact..."
AnonymousAnonymous posted an answer for this Motorcycles:
"My bike turn off every time is in N and I put the kick stand down! What's the problem? Is..."
AnonymousAnonymous posted a question about Motorcycles:
"I have a 04 rm250. I need to know how many pins on the timing chain so I can set the..."
Anonymous
Motorcycles 14 answers
