2
Anonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"black lines on confirmation page"
AnonymousAnonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"most likely drum unit."
Anonymous
Anonymous posted an answer for this Brother IntelliFAX 5750e Laser Fax:
"my lcd screen is not showing up (can't see any letters/numbers) help me?"
AnonymousAnonymous posted an answer for this Brother IntelliFAX 5750e Laser Fax:
"your display is bad and must be replaced.razors"
Anonymous
Anonymous posted an answer for this Brother IntelliFax-4100e Fax:
"My fax machine keeps going into sleep mode. How can I prevent this from happening?"
AnonymousAnonymous posted an answer for this Brother IntelliFax-4100e Fax:
"you can't. you can only change the length of time before it enters sleep mode. (00-99..."
Anonymous
Anonymous posted an answer for this Brother Office Equipment & Supplies:
"I want to buy MagicJack Plus. Is this fax machine compatable with this device?"
AnonymousAnonymous posted an answer for this Brother Office Equipment & Supplies:
"good question. i really could not tell you from personal experience.razors"
AnonymousAnonymous posted an answer for this Brother Office Equipment & Supplies:
"I have tried to isolate the noise but have been unable to locate it other than the upper..."
AnonymousAnonymous posted an answer for this Brother Office Equipment & Supplies:
"ok. one item i have seen cause a problem in that area is a white gear that is attached by..."
AnonymousAnonymous posted an answer for this Brother IntelliFax-4100e Fax:
"My brother 4100e fax prints a black band down the entire side of every page. This band is..."
AnonymousAnonymous posted an answer for this Brother IntelliFax-4100e Fax:
"print a report, any report, from your control panel. if it looks good and your band is..."
Anonymous
Anonymous posted an answer for this Brother IntelliFax-2820 Laser Fax:
"where is the back door sensor located"
AnonymousAnonymous posted an answer for this Brother IntelliFax-2820 Laser Fax:
"open your rear door and you'll see that a black guide will open also. on the black..."
Anonymous
Anonymous posted an answer for this Brother HL 5250DN Laser Printer:
"First problem was the whole page was smearing when printing. I replaced the drum and there..."
AnonymousAnonymous posted an answer for this Brother HL 5250DN Laser Printer:
"smearing can be interpreted different ways. if paper stalls, it will cause "stretched"..."
AnonymousAnonymous posted an answer for this Brother Office Equipment & Supplies:
"WHEN FEEDING THE DOCUMENT THRU THE TOP FEEDER FOR PHOTOCOPYING, THE PHOTOCOPY HAS VERTICAL..."
AnonymousAnonymous posted an answer for this Brother Office Equipment & Supplies:
"you didn't state model #, but raise your feeder up and look for the "skinny" piece of..."
AnonymousAnonymous posted an answer for this Brother HL 5250DN Laser Printer:
"I still receive the error message "Replace Drum", "Drum End Soon",..."
AnonymousAnonymous posted an answer for this Brother HL 5250DN Laser Printer:
"did you do the reset procedure? if not it's in your owners manual under the section..."
Anonymous
Anonymous posted an answer for this Brother IntelliFAX 750 Plain Paper Thermal transfer Fax:
"I can receive and print a fax but when I send or copy a fax the result is all black. How..."
AnonymousAnonymous posted an answer for this Brother IntelliFAX 750 Plain Paper Thermal transfer Fax:
"the cause is your CIS or Contact Image Sensor. the last i knew, they were a little over..."
AnonymousAnonymous posted an answer for this Brother IntelliFax-2820 Laser Fax:
"My fax 2820 has mn1 in the corner of the function window where it should read fax, and is..."
AnonymousAnonymous posted an answer for this Brother IntelliFax-2820 Laser Fax:
"hit "menu/set", "0", then "1". using arrows to select "fax only", hit "menu/set",..."
Anonymous
Anonymous posted an answer for this Swintec 7040 Typewriter:
"move your carriage to right margin by using "tab" or "space bar". then press "margin..."
Anonymous
Anonymous posted an answer for this Brother MFC-8220 Fax:
"We recently purchased second hand this printer and fax unit. when I plug the fax into the..."
AnonymousAnonymous posted an answer for this Brother MFC-8220 Fax:
"first, as a tech, i would make sure your phone jack works, then also make sure the line is..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"that indicates that your laser has went bad. definetly have to have a tech to replace..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"error 71 brother mfc 8640D. What should I do?"
Anonymous
Office Equipment &... 212 answers
