1
Anonymous posted an answer for this Canon PC-941 Copier:
"Pull the paper tray out of the machine. On the right side underneath you should see a..."
Anonymous
Anonymous posted an answer for this HP Office Equipment & Supplies:
"Is the machine set to auto receive? Try unplugging the power for a few seconds. This may..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"Look into the machine as you try and shredding a single sheet of paper. Are the cutters..."
Anonymous
Anonymous posted an answer for this Cross Infoguard Shredder SX102M:
"Sadly, light duty machines as yours do overheat and shut off. Shredders are rated for run..."
Anonymous
Anonymous posted an answer for this Brother GX-6750 Typewriter:
"Look inside the machine and make sure nothing has fallen into it that may be blocking the..."
AnonymousAnonymous posted an answer for this Brother GX-6750 Typewriter:
"Be sure the the ribbon has not run out or is jammed. You can test this by rotating the..."
Anonymous
Anonymous posted an answer for this IBM Wheelwriter 30 Typewriter:
"To change the font size you need to install a different printwheel. There are places on..."
Anonymous
Anonymous posted an answer for this Canon imageRUNNER C6800 Copier:
"I don't have the manual for this machine, but if Canon is consistent then you problem is a..."
AnonymousAnonymous posted an answer for this Canon imageRUNNER C6800 Copier:
"This code indicates a failure of the fuser Unit (the device that melts the ink onto the..."
AnonymousAnonymous posted an answer for this Brother Office Equipment & Supplies:
"As you face the machine, the full spool goes on the left side of the printwheel carriage..."
Anonymous
Anonymous posted an answer for this Brother IntelliFax-2820 Laser Fax:
"The error indicates that the controller detects paper that is smaller than letter size in..."
AnonymousAnonymous posted an answer for this Brother IntelliFax-2820 Laser Fax:
"This means that you have 99% free memory."
Anonymous
Anonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"The mode is correct. You can check the rings to answer setting. Default is 4 rings. If..."
AnonymousAnonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"If your machine is a Brother 4100 you can clear the drum message by pulling the drum out..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"The problem can be either a error with your phone service or an incompatablity with your..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"I call my tech support. The problem does have to do with an abnormal reading of the Toner..."
AnonymousAnonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"To see if the phone line is causing the problem, try moving the machine to a different..."
Anonymous
Anonymous posted an answer for this Brother IntelliFax-2920 Plain Paper Fax, Copier and Phone , 33.6 Kbps Modem Laser:
"Put the old tone back in machine. Does the problem still exist? If not try another new..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"The MNL setting has no effect on sending. Try unplugging the power for 10 seconds to see..."
Anonymous
Anonymous posted an answer for this Brother IntelliFAX 1840C Plain Paper Inkjet Fax:
"All you can print out is the tranmission report. It will show the fax number the item was..."
AnonymousAnonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"Try removing the Toner/drum unit and see if paper is there. Also check the rear access..."
AnonymousAnonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"The noise may be caused by the toner cartridge binding up. This can happen with..."
AnonymousAnonymous posted an answer for this Brother IntelliFAX 4100 Laser Fax:
"If you are scanning using the Auto Document Feeder be sure to clean the glass where the..."
Anonymous
Office Equipment &... 23 answers
